User manual APRILIA RSV 1000 R

[. . . ] EPA AND CALIFORNIA REGULATIONS APPLICABLE TO 2004 MODEL YEAR NEW MOTORCYCLES AND IS CERTIFIED TO 1. 4 HC+NOx G/KM ENGINE FAMILY EXHAUST EMISSION STANDARD IN CALIFORNIA. ENGINE EXHAUST CONTROL SYSTEM: HO2S-2OC 0XIIOHU VWDPSLQJ Do not use any tire other than those reccomended and approved by Aprilia. Failure to follow these warnings can lead to an accident and serious injures or death. See owner's manual. 2. 3 (33. 4) 2. 5 (36. 3) 2. 5 (36. 3) Pirelli - Metzler Michelin Dunlop (36. 3) 2. 8 (40. 6) 2. 8 (40. 6 ) Pirelli - Metzler Michelin Dunlop (58W) (56W) (73W) (73W) RRC RRU MOTORCTCLE NOISE EMISSION CONTROL INFORMATION THIS 2004 ASPRRC0998 MOTORCYCLE. [. . . ] Then, try your vehicle in a parking lot or other safe area with little traffic to ensure that the brakes are working properly. Failure to observe this warning can lead to a serious accident with subsequent serious injury or death. 9 11 Keep your fingers clear. Insert the brake caliper (10) over the disc and place it so that its fastening holes and the holes on the support are aligned. 10 9 REMOVING THE FRONT BRAKE CALIPERS WARNING When reassembling the brake caliper, replace the caliper screws (9) with two new screws of the same type. Operate on the second brake caliper: Repeat the operations marked with . Remove the front support stand (7), see page 108 (PLACING THE VEHICLE ON THE FRONT SUPPORT STAND) . WARNING The disassembly and reassembly of the front brake calipers can be difficult for those unfamiliar with vehicle maintenance. You may wish to have your Local aprilia Dealer carry out these operations. The front brake system is equipped with two separate calipers, one on the left and one on the right side of the vehicle. The following information may refer to only one brake caliper but is applicable t o b o t h . W h i l e d i s as s e mb l i n g a n d reassembling the front brake calipers, pay extra care not to damage the brake lines, discs or pads. 122 use and maintenance RSV 1000 R USA - RSV 1000 RFACT USA NOTE You must use the appropriate front and rear support stands (7) (8) to remove the front brake calipers. DISASSEMBLY Place the vehicle on the appropriate front support stand , see p. 108 (PLACING THE VEHICLE ON THE FRONT SUPPORT STAND ). 9 11 Screw in the two bolts (9) by hand until they rest on the caliper. To park the vehicle without the stand only the rear support stand may be used. WARNING Removal of the safety pegs (7) fitted to the rider footrests is only allowed after removal of the side stand. WARNING Failure to remove the side stand before using your vehicle in competition can result in reduced cornering clearance. This could lead to a serious crash with subsequent serious injury or even death. WARNING Never disconnect or remove the safety switch (4) without also removing the stand. Disconnecting or removing the safety switch (4) only makes it possible to start the vehicle and ride off with extended stand which may result in upset, and serious injuries or even death to the rider or bystanders, and damage to the vehicle. NOTE Removing the safety switch (4) disconnects the electrical circuit, and your vehicle' s engine will not run with the transmission in gear. 124 use and maintenance RSV 1000 R USA - RSV 1000 RFACT USA 7 9 15 To remove the side stand: Remove the left side cover, see p. 117 (LIFTING THE FUEL TANK). 14 13 12 11 Torque wrench setting for screws (11) and (13): 40 Nm (4 kgm). Unscrew and remove the screw (13) while holding the nut (15) at the rear end with a wrench. Remove the stand (1) complete with: springs (2); bracket (3); stand switch (4). Refit the screw (13), the washer (14) and the nut (15) and tighten to the specified torque. NOTE Support the stand, in order to prevent it from accidentally falling down. NOTE Obtain a tie-wrap (7) to use for reassembly. CAUTION Do not force cables, tubes, lines, connectors and wires. Disconnect the electric connector (10) from the connector (5). use and maintenance RSV 1000 R USA - RSV 1000 RFACT USA 125 12 If any fastener in the throttle system becomes loose, likewise you will lose control of your vehicle. Either situation can lead to an upset or collision with subsequent serious injury or death. One cable opens the throttle when you rotate the throttle grip toward you; the other closes the throttle when you rotate the grip away from you. [. . . ] 0090-212-3360057- Email:sule@interline. com. tr Hold utca 23 - H-1054 - Budapest Tel. 00351-229371305 - Email: milfa@milfa. pt Rizareiou 4 - 15233 - Halandri Tel. 0030-210-6898056 - Email: aprilia@otermail. gr Bernerstrasse Nord 202 - 8064 - Zurigo Tel. 0041-1-4348686 - Fax 0041-1-434 8606 - Email: agonser@mohag. ch Landegemstraat 4 - Industriegebied - B-9031 - Drongen-Baarle Tel. [. . . ]