User manual APPLIED ENERGY XPLUS 250 DC

[. . . ] b) The appliance has been correctly installed in accordance with our instructions and is being used on the supply circuit or voltage printed on the rating plate. c) The appliance has been used in accordance with these instructions and has not been tampered with or otherwise subject to misuse, neglect or accident. d) The appliance has been regularly maintained in accordance with these instructions and the airway is unobstructed. [. . . ] WARNING: THIS PRODUCT IS FOR CONNECTION TO 1 PHASE SUPPLY ONLY, DO NOT CONNECT TO 3 PHASE SUPPLY. Installation and wiring must conform to current IEE regulations (UK), local or appropriate regulations (other countries). It is the Installers responsibility to ensure that the appropriate building codes of practice are adhered to. If there is damage to the fitted lead this must be replaced by the manufacturer or service agent. If you have any queries before installing these products or after they are installed, call the Xpelair Technical Hotline +44 (0) 8709 000430. Our engineers are there to help during normal office hours (UK only) and may be faxed at all other times on +44 (0) 8709 000530. Customers outside the UK please contact your local Xpelair distributor, details of which are available from the UK office. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. For flexible ducting, you will need worm drive clips (available from Xpelair) to attach the ducting to the fan inlets and outlet. If installing in a position where condensation is likely to run back towards the fan, you will need a suitable condensation trap. Where to locate it Position of air intake Connecting the fan As far as possible from and opposite to the main source of air replacement to ensure airflow across the room (e. g. Not where ambient temperatures are likely to exceed 50oC, or above a cooker hob or eye level grill. If installing in a room containing a fuel burning device, it is the installer's responsibility to ensure that there is enough replacement air to prevent fumes being drawn down the flue when the fan is operating up to maximum extract. Exhaust air must not be discharged into a flue used for exhausting fumes from appliances supplied with energy other than electric. Requirements of all authorities concerned must be observed for exhaust air discharge. [. . . ] 2. Mount the fan, using appropriate fasteners through the mounting holes provided. Attach the ducting over the inlets and outlet and secure it with worm drive clips. 6 3 B3 A ISOLATING SWITCH (ALL POLES DISCONNECTION) A2 A1 LF NF N FUSE GREY BLACK CABLE FROM Xplus UNIT N L L BROWN GREEN/YELLOW Where to locate it AQS CONTROLLER TERMINALS Xplus DC WIRED THROUGH AN AQS CONTROLLER REF. 92097AW B4 N L ISOLATING SWITCH (ALL POLES DISCONNECTION) FUSE TERMINAL BLOCK (NOT SUPPLIED) GREEN/YELLOW CABLE FROM Xplus UNIT N L BLACK BROWN GREY COS SWITCH Xplus DC WIRED THROUGH A COS SWITCH REF. [. . . ]