User manual APPLIED ENERGY MONOBLOCK CHROME

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual APPLIED ENERGY MONOBLOCK CHROME. We hope that this APPLIED ENERGY MONOBLOCK CHROME user guide will be useful to you.


APPLIED ENERGY MONOBLOCK CHROME : Download the complete user guide (24 Ko)

Manual abstract: user guide APPLIED ENERGY MONOBLOCK CHROME

Detailed instructions for use are in the User's Guide.

[. . . ] Monoblock Chrome Mixer Tap Installation and User Instructions (To be left with user after installation) READ AND SAVE THESE INSTRUCTIONS FOR THE BENEFIT OF THE USER Important!Ø Ø Ø Ø This mixer tap is only to be used in conjunction with the standard "WS7" Water Heater. [. . . ] · A large flat rubber washer (supplied), should be located around the threaded portion of the mixer block directly under the sink-worktop, · A large plastic nut (supplied), should be screwed onto the threaded part of the mixer block with the flange uppermost. Note: - Some extra small parts are included in the kit which are not necessary to complete the installation with the WS7 water heater. PLUMBING CONNECTIONS · The Chrome Monoblock Mixer Tap is supplied with three 8mm diameter annealed copper pipes attached. · Connection to the WS7 water heater will be made by use of 15mm copper pipe. · It is recommended that 8mm ­ 15mm compression adapters are used. Note: - If soldered adapters are selected it is recommended that the chromium finish is removed at the point where the solder joint is made. Inlet Cold Water · This is connected to the Chrome Monoblock Mixer Tap and not to the water heater. · Connection is made to the pipe marked with a blue arrow which points up towards the mixer block. . Outlet Cold Water · Connection is made from the pipe of the mixer block which is marked with a blue arrow which points down away from the mixer. INLET HOT WATER · · · · This is connected from the water heater hot outlet WHICH IS MARKED RED to the pipe going to the mixer block, which is marked with a red arrow pointing towards the mixer. Turn the temperature regulation knob (marked with a red and a blue arrow) fully in the direction of the red arrow. Only when the water heater is full will the water flow out of the heater and out of the mixer tap spout. It is possible that air will be expelled in spurts when the water heater is first commissioned. Switch on the electricity supply to the water heater ONLY AFTER A STEADY STREAM OF WATER IS SEEN ISSUING FROM THE SPOUT OF THE MIXER TAP. . OPERATING THE CHROME MONOBLOCK MIXER TAP There are two knobs on the mixer tap. The knob marked with a red and blue arrow regulates the water temperature. [. . . ] · Evidence of the date of purchase in the form of an invoice, receipt (hire purchase documents) is included with the appliance of returned under guarantee. Full details of terms and conditions of guarantee are available on request from:- APPLIED ENERGY PRODUCTS LIMITED MORLEY WAY, PETERBOROUGH PE2 9JJ TEL +44 (0) 1733 456789 / FAX: +44 (0) 1733 310606 Website: www. redring. co. uk (Leaflet No:- 578-2137-01A) [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE APPLIED ENERGY MONOBLOCK CHROME




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual APPLIED ENERGY MONOBLOCK CHROME will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.