User manual APPLIED ENERGY FR22-30

[. . . ] These Instructions are for the Installation and Operation of the FR22/30 Fan Controller only. This appliance is designed to control the operation of Xpelair fans of the GX9, GX12, WX9, WX12, RX9 & RX12 ranges (wall & window mounted). The controller may be either surface mounted, or recess mounted within it's own patress box. [. . . ] When intended for use in possible chemical corrosive atmospheres, consult our Technical Service Department (Outside the UK contact your local Xpelair distributor). If installed in a shower room or bathroom the controller and isolating switch must be situated so that they cannot be touched by persons making use of the bath or shower. 1 Detach the Fascia from the Mounting Frame by removing the screw covers and two screws (Refer to Fig. 2 Detach the Mounting Frame from the Wall Box by removing the two screws (Refer to Fig. 4 Check that the electrical rating shown inside the controller matches the power supply. 2 Route the Cable from the Isolating Switch to the point of connection to the power supply. 3 Make all connections within the Isolating Switch in accordance with the manufacturers instructions. 4 Following all local regulations make connection at point of power supply. 5 Make a final check to ensure all earth points are connected and all covers have been correctly replaced on the fan, controller and isolating switch. For fixed wiring circuits the protective fuse for the appliance must not exceed 5 amps. for Australia only: These models are permanently connected to the supply & operation is controlled by a remote switch. They should be directly wired to the supply through an approved 10 amp wall mounted surface switch with at least 3mm clearance between contacts. Eye protection must be worn during all drilling & chiselling operations. Check there are no buried Pipes or Cables in the wall or obstructions on the outside e. [. . . ] X If you have any problems, contact Xpelair's Head Office at the address shown below. UK: Xpelair have a comprehensive range of services including: x Free technical advice help-desk from Engineers on all aspects of ventilation. Please ask for details: x By telephone on Techline: +44 (0)8709 000430 x By fax on Techfax: +44 (0)8709 000530 x At the address below. [. . . ]