User manual APPLIED ENERGY DT20B

[. . . ] UK: Xpelair have a comprehensive range of services including: Free technical advice help-desk from Engineers on all aspects of ventilation. Please ask for details: By telephone on Techline: +44(0) 8709 000430 By fax on Techfax: +44(0) 8709 000530 At the address below Guarantee - Contact your local distributor or Xpelair direct for details. Technical advise and service - Contact your local Xpelair distributor. Applied Energy Products Ltd Morley Way Peterborough PE2 9JJ t 01733 456789 f 01733 310606 www. applied-energy. com Xpelair is a registered trademark of Applied Energy Products Limited. [. . . ] Applied Energy Products reserve the right to alter product specifications or appearance without prior notice. All finishes and diagrams in this booklet are as accurate as printing processes allow. Xvent multipoint ventilation unit Xvent 275 Leaflet Part No. 22750AA (Revision B) Xpelair Multipoint ventilation unit Installation and Operating Instructions PLEASE LEAVE THIS LEAFLET WITH THE FAN, FOR THE BENEFIT OF THE USER A Position of air intake These products are intended for connection to fixed wiring. Check that the electrical rating shown on the products matches the mains supply. WARNING: THIS PRODUCT IS FOR CONNECTION TO 1 PHASE SUPPLY ONLY, DO NOT CONNECT TO 3 PHASE SUPPLY. Installation and wiring must conform to current IEE regulations (UK), local or appropriate regulations (other countries). If there is damage to the fitted lead this must be replaced by the manufacturer or service agent. Ducting accessories, including internal and external grilles and fasteners. For flexible ducting, you will need worm drive clips (available from Xpelair) to attach the ducting to the fan inlets and outlet. If installing in a position where condensation is likely to run back towards the fan, you will need a suitable condensation trap. At least 0. 5m away from open door or window, or the inlet of another ventilation device. 1. Install the ducting to connect the fan to the air intakes and to the outlet. If installing in a position where condensation is likely to run back towards the fan, install a condensation trap as near to the fan as possible. 1. Mount the fan, using appropriate fasteners through the mounting holes provided. [. . . ] Mount the fan, using appropriate fasteners through the mounting holes provided. Attach the ducting over the inlets and outlet and secure it with worm drive clips. 1. Connect the cable from the isolating switch to the electrical supply wiring. [. . . ]