User manual APPLIED ENERGY AWC

[. . . ] These instructions are for the Installation and Operation of the AWC Fan Controller only. If you have any queries either before, during or after the installation of the controller, please do not hesitate to contact the UK Xpelair hotline (number on back page). What the installer will need · If using flexible cable, suitable glands incorporating cable clamps must be fitted to the knockouts in the Controller Box. [. . . ] ⷠThe AWC can be either surface or recess mounted using the metal wall box supplied. Installing the Controller These installation instructions are for the installation of the controller when used in combination with Xpelair supplied fans. Working with the Fan If wiring to an existing installation isolate mains supply and remove applicable fuses prior to any electrical procedure. Disconnect the mains connections from the fan's terminal socket or from the terminal block. Route the three core cable from controller position to the isolator position. Detach the Fascia from the Mounting Frame by removing the screw covers and two screws (Refer to Fig. Detach mounting Frame from the Wall Box by removing the two screws (Refer to Fig. Check that the electrical rating shown inside the controller matches the power supply. Mounting the Wall Box Eye protection must be worn during all drilling and chiselling operations. Check there are no buried Pipes or Cables in the wall or obstructions on the outside e. Fix the Wall Box and Plastic Surround to the wall, using the mounting holes provided. Ensure that the flange of the mounting frame fits flush to the finished surface of the wall (Refer diagram F3. Mounting the Sensors Using the two clips supplied, mount the temperature sensors horizontally, without touching the walls or ceiling. ⷠMount the sensor with the 10m cable in the high level position. ⷠMount the sensor with the 1m cable in the low level position suitably protected. ⷠInstall the cables in closed conduits, leaving the other ends ready to wire into the controller. [. . . ] The controller is guaranteed against defects for 3 years from the date of purchase. If you have any problems, contact Xpelair's Head Office at the address shown below. Free technical advice help-desk from Engineers on all aspects of ventilation. [. . . ]