User manual APPLIED ENERGY 650

[. . . ] Adjust for variations of incoming mains water temperature between summer and winter. The electricity to the elements is then disconnected and the adjacent light will flash, water will continue to flow for approximately 5 seconds before switching off. This reduces the temperature of the water in the unit for the next user. Your shower is designed to stabilise temperature changes caused by water pressure fluctuations. [. . . ] The frequency of this will vary from weekly to quarterly depending on the water hardness and experience. Check the spray plate is then free to rotate to give the three settings. In some winter conditions, when the incoming mains water is particularly cold it may be necessary to select the inner or outer spray pattern only. This will ensure correct operation of the shower with a slightly lower water flow rate Note: After use it is normal for some water to drip from the showerhead for a few moments, this inhibits scale build up over prolonged use. 4 What to do if things go wrong SELF HELP If the shower is unsatisfactory, make the following checks before calling out the contractor. Any of these adjustments could restore the performance Increase water flow by adjusting the temperature control clockwise. b) Water too COLD Decrease water flow by adjusting the temperature control anti-clockwise. Check power setting lights are on Check water pressure has not fallen so far as to let pressure switch cut out, e. g. Fitting instructions are provided with spares. c) Spray pattern poor d) Water goes cold while using shower e) Broken parts PROFESSIONAL SERVICE If the previous checks fail to restore the performance, you should either contact the Redring Technical Advisory Service or seek the assistance of a qualified plumber and / or electrician. The person who installed the shower is probably the best one to repair it and is certainly the person to contact if you have a problem in the guarantee period. The following additional checklist is provided for the benefit of the qualified serviceman. WARNING ­ SWITCH OFF THE ELECTRICITY AT THE ISOLATING SWITCH BEFORE REMOVING THE COVER TO MAKE CHECKS. Switch off water and undo a) Water too HOT plastic nut on elbow, loosen brass nut to swing elbow away from solenoid. Check circuit through thermal cut-out Check circuit through microswitch on the b) Water too COLD pressure switch Check each element circuit. c) Water leaks from burst pressure relief Replace the pressure relief disc. Check circuit through microswitch d) Water does not flow when button "A" Possible PCB fault, if defective, then replace. 5 Installation instructions Check that the electrical rating shown on the showers matches the mains supply. If in any doubt, advice and assistance should be sought from a qualified plumber and/or electrician. Installations and wiring must conform to current BS7671 IEE regulations (UK) WARNING!DO NOT INSTALL THIS SHOWER IN A ROOM WHERE IT MAY BE SUBJECT TO FREEZING We recommend that the installation be done in the following sequence. a) Fixing the shower to the wall b) Plumbing c) Electrical connections a) Fixing the shower to the wall 1. Position the riser rail at the height recommended in diagram 5 and mark its position. [. . . ] WARNING - TAKE CARE WHEN REPLACING THE FRONT COVER TO AVOID DAMAGING ANY COMPONENTS. Operate the shower first without the handset to flush out particles, fit handset and then operate the shower as explained previously and check: a) That the water gets to a satisfactory temperature. LEAVE THESE INSTRUCTIONS WITH THE USER FOR FUTURE REFERENCE. Diagram 11 9 How to maintain your shower It is recommended that the shower unit, riser rail, hose etc. can be cleaned using a soft cloth and that the use of an abrasive or solvent cleaning fluid be avoided, especially on any plated finishes (650 chrome only). [. . . ]