User manual APEX DIGITAL DT502

[. . . ] When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. [. . . ] Make sure the converter box is in Standby mode ­ the power indicator light should be red; otherwise, press the Power button on the converter's remote control. This step only need to perform once after connection and it is only require if you did not scan the local channel before ­ scan analog channels by following the instruction of your TV. You may connect the unit to your stereo system using the following method: Due to the nature of digital broadcasts, the normal image displayed on your television may appear as a "windowbox" or "letterboxed" image. This is a normal condition based on signal transmission and programming. A windowbox image is typical when viewing DT broadcasts that are not widescreen presentations. A letterbox image is typical when viewing DT broadcasts that are presented in widescreen format. When viewing TV broadcasts on a widescreen television you will find that SD programing does not fill the display entirely. Press ZOOM on the remote control until the display area is filled and black bars are minimized. Once all connections are made, follow this Quick Start Guide to begin viewing digital channels immediately. It is recommended that you read the entire manual to familiarize yourself with all of the functions available to you. When the converter box is turned on for the first time or has been reset to factory default, the Installation Guide will be displayed automatically. OSD Language Press [ t / u ] to select the menu language (English, Spanish, or French), then press [ OK ] to Confirm Time Zone / Daylight Saving Press [ t / u ] to select your time zone (Hawaii, Alaska, Pacific, Mountain, Central, Eastern) , then press [ q ] to move the cursor to adjust the Auto Daylight Saving using [ t / u ], then press [ OK ] to Confirm and auto scanning will proceed. If "No" is selected, programs will display times according to the set time zone without Daylight Saving. Auto Channel Scan Your converter box searches for available channels in your area and stores them in the channel memory. To stop scan during Auto Scan, press the [ EXIT ] button and the screen will be directed to the first scanned channel Setup Completed The system is configured as followed: OSD: English Time Zone: Pacific (-8:00) Daylight Savings: AUTO Detected Digital Channel: 51 Detected Digital Frequencies: 22 Press OK to complete a setup and exit to watch TV Setup Complete After auto channel scan is done, press [ OK ] to complete the setup and began to watch TV. To display the correct information on Simple Guide, Full Guide, and Reminder List, your "Time Zone" must be set correctly. While highlighting a program, press [ OK ] to add or release the program to the Reminder List You can view a list of programs scheduled for the next few hours. Press [ GUIDE ] on the remote control twice to display or Press [ MENU ] on the remote control to display the On-Screen Menu and follow the steps below: 1. [. . . ] This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particularinstallation. [. . . ]