User manual APC SMART-UPS RT 3000VA

[. . . ] Therefore these units do not meet the requirements for use in direct patient care. 1 BATTERY SAFETY This equipment contains potentially hazardous voltages that may cause personal injury if handled incorrectly. This equipment must be installed and serviced only by qualified electrical service personnel. Repairs are to be performed only by factory trained service personnel. [. . . ] The connector is color-coded and keyed to prevent improper connection. Use the battery pack connector to daisy-chain multiple battery packs to the same UPS. The connector is color-coded and keyed to prevent improper connection. Battery Pack Connector INSTALLING THE BATTERY PACK To install one or multiple battery packs in the tower configuration, follow these basic steps. REMOVE AND EXPAND THE UPS FEET The UPS is heavy, remove the battery tray to lighten it. Instructions to remove the battery tray and the feet can be found in your UPS User’s Manual. 4 1. Once the feet have been removed, snap apart each foot into two end brackets. 2. Each foot needs one expansion piece for each external battery pack you are using. Additional expansion pieces are shipped with the external battery packs. Snap all center expansion pieces together, and then snap the brackets back onto the ends of the expansion piece(s) to complete the foot. Repeat with the other foot. REMOVING THE BATTERY TRAYS FROM THE BATTERY PACK The battery pack is heavy. Battery trays in your external battery pack are installed and removed just like the battery tray found in your UPS. The battery trays are accessible from the front of the battery pack (shown at left). The External Battery Pack is shipped with the bezel removed, but the top decorative panel attached. If your external battery pack has been in operation, you will need to remove the top decorative panel and front bezel before gaining access to the battery compartments. Continue following instructions in the UPS User’s Manual section Remove and Reinstall Battery Pack to remove the battery doors, disconnect batteries (if the battery pack has been in use; the batteries are shipped disconnected) and remove the battery trays. POSITIONING THE BATTERY PACK AND UPS If more than 2 external battery packs are to be connected to the UPS, you will need more than one person to properly support and rotate the attached units during the installation, even after removal of all battery trays. 5 1. [. . . ] Disregard the message, “. . . must install a modem, ” if it is displayed. The port settings are 2400 baud, 8 data bits, 1 stop bit, no parity, flow control off. Once the terminal window is open, follow these steps to enter the number of external battery packs using the terminal mode within the Smart-UPS RT: Hit the Enter key to initiate terminal mode. [. . . ]