User manual APC SMART-UPS 750VA LCD 230V

[. . . ] 4 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Hardware Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 About the Web Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 3. 1 3. 2 Access the Router . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] There are four types of One-to-One, Many-to-One, Rule Type Many-to-Many Overload and Many-to-Many No-overload. Local Start IP is the starting local IP address and Local End Local Start/ End IP IP is the ending local IP address. If the rule is for all local IPs, then the Start IP is 0. 0. 0. 0 and the End IP is 255. 255. 255. 255. Public Public Start/ End IP Start IP is the starting public IP address and Public End IP is the ending public IP address. If you have a dynamic IP, enter 0. 0. 0. 0 as the Public Start IP. 35 SMART-UPS 750VA LCD 230V User Manual 3. 5. 4 QoS Choose Advanced Setup > QoS, the page shown in the following figure appears. This option provides better service of selected network traffic over various technologies. The QoS can be set based on the physical LAN ports or wireless interfaces. The following table describes the parameters of this page: Field QoS Description You may select Activated or Deactivated. After activating 36 SMART-UPS 750VA LCD 230V User Manual Field interface. Rule Index Active Application Physical Ports Destination MAC The Destination MAC address of the rule. If data packets include the MAC address, the data packets are placed into the group. If data packets IP Port Range Source MAC IP Protocol ID include the IP address, the data packets are placed into the group. Please check the proper settings with your Internet service provider. The router supports these modulations: G. Lite, T1. 413, G. DMT, ADSL2, ADSL2+ and Auto Sync-Up. The following table describes the parameters and buttons of this page: Field ADSl Mode ADSL Type Description Choose Auto Sync-Up, ADSL2+, ADSL2, G. DMT, T1. 413 or G. lite. Choose ANNEX A, ANNEX I, ANNEX A/L, ANNEX M or ANNEX A/I/J/L/M. 3. 6 Access Management In the navigation bar, click Access Management. The Access Management page that is displayed contains ACL, Filter, SNMP, UPnP and DDNS. 3. 6. 1 ACL Choose Access Management > ACL, and the page shown in the following figure appears. The user may remotely access the ADSL Router once setting his IP as a Secure IP Address through selected applications. With the default IP 0. 0. 0. 0, any client would be allowed to remotely access the ADSL Router. 42 SMART-UPS 750VA LCD 230V User Manual The following table describes the parameters and buttons of this page: Field ACL Rule Index Active Secure IP Address Application Interface Access control Listing Support Web, FTP, Telnet, SNMP, Ping and ALL. Only the devices whose MAC addresses are listed in the Access Control Listing can access the router. The rule is valid if the IP is in this range. 3. 6. 2 Filter Choose Access Management > Filter, and the page shown in the following figure appears. The user can set IP/MAC Filter, Application Filter and URL Filter. 3. 6. 2. 1 IP/MAC Filter Choose Access Management > Filter, and the page shown in the following figure appears. The user can set different IP filter rules of a given protocol (TCP, 43 SMART-UPS 750VA LCD 230V User Manual UDP or ICMP) and a specific direction (incoming, outgoing, or both) to filter the packets. The following table describes the parameters and buttons of this page: Field Filter Type Selection IP/MAC Filter Rule Index Interface Direction Filter. Description Support IP / MAC Filter, Application Filter and URL 44 SMART-UPS 750VA LCD 230V User Manual Field Rule Type Source IP Address Port Number Destination IP Address Protocol Enter the Port Number. [. . . ] Get Community: Select to set the password for the incoming Get requests from the management station. Set Community: Select to set the password for incoming Set requests from the management station. UPnP UPnP (Universal Plug and Play) is a distributed, open networking standard that uses TCP/IP for simple peer-to-peer network connectivity between devices. A UPnP device can dynamically join a network, obtain an IP address, convey its capabilities and learn about other devices on the network. [. . . ]