User manual APC BACK-UPS RS 550VA
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual APC BACK-UPS RS 550VA. We hope that this APC BACK-UPS RS 550VA user guide will be useful to you.
Manual abstract: user guide APC BACK-UPS RS 550VA
Detailed instructions for use are in the User's Guide.
[. . . ] The socketoutlet that you plug into shall be located near the equipment and shall be easily accessible. The socket-outlet must be a grounding type.
0 - 40oC
Battery Backup plus
Surge Protection
Surge Protection
3
Operation and Software Installation
Press the ON/OFF switch to power the unit ON. A single short beep and the green “Power On” indicator confirms that Back-UPS ES is on and ready to provide protection. [. . . ] Constant tone
Red
Alternating Amber and Green
None
Shutdown - Occurs when the UPS is operating On Battery and has shutdown the applications running on the connected computer and has shutdown the computer. Unit is online and battery is disconnected.
2
Lift the battery out of the UPS. Battery Terminal Battery Wire
Green and Amber, flashing
Beeps every 2 seconds.
UPS power switch is turned OFF or when the battery is connected.
See the Troubleshooting section for additional assistance.
3
Connect the two wires to the replacement battery and install the battery into the unit.
4
Slide the battery cover on the unit until it locks in place.
990-1466A Copyright © 2009 American Power Conversion Corp. All rights reserved.
APC, Back-UPS and PowerChute are registered trademarks of American Power Conversion Corp. All other trademarks are property of their respective owners.
Troubleshooting
Problem
Use the table below to solve minor Back-UPS ES installation or operation problems. Consult APC Online Technical Support or call APC Technical Support for assistance with problems that cannot be resolved using the table below:
Problem
Probable Cause
Battery is disconnected and utility power is not available at the wall outlet. Utility power not available at the wall outlet.
Solution
Solution
Back-UPS ES will not turn on. No power available at the Surge Protection outlet.
Connect the battery (see Battery Replacement) and ensure power is available at the wall outlet. Move equipment plugged into Surge Protection outlet to Battery Backup plus Surge Protection outet. Ensure that the fuse or circuit breaker for the outlet is not tripped, and that the wall switch controlling the outlet (if any) is in the ON position. Ensure that the equipment you want to stay powered during a power failure is plugged into the “Battery Backup plus Surge Protection” outlets and NOT the “Surge Protection” outlet. Make sure the equipment plugged into the outlets of the unit are not overloading the capacity of the unit. Try disconnecting some of the equipment and see if the problem continues. The Back-UPS ES can only operate on battery power for a limited amount of time.
Connected equipment loses power.
Equipment is connected to the “Surge Protection” outlet. [. . . ] Verify the battery is connected (see Battery Replacement) and the Circuit Breaker is not tripped (see Troubleshooting section). If you still have problems or questions, please contact APC via the internet or at one of the phone numbers listed below. Before contacting APC, please be sure to record the date purchased, UPS model, and serial number (on bottom of unit). [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE APC BACK-UPS RS 550VA
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual APC BACK-UPS RS 550VA will begin.