User manual AOPEN SV520

[. . . ] If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the purpose of the grounding-type plug. 8. Do not allow anything to rest on the power cord. Do not locate this product where persons will 3 A Open SV520 walk on the cord. 9. Online Manual If an extension cord is used with this product, make sure that the total ampere rating of the equipment plugged into the extension cord does not exceed the extension cord ampere rating. [. . . ] See "Opening the housing panel" on page 25 for more information. Attaching the 3. 5" storage devices to the 5. 25" plastic casing with four screws. Attaching the drive rail to one side of the plastic casing and secure it with two screws. Do the same thing to the other side. 29 A Open SV520 4. Online Manual Insert the casing into the bay. See "Removing drive bay covers" on page 28. 5. Secure the casing with two screws. A Open 30 SV520 Online Manual 6. 7. Connect the power cable and signal cables to the storage devices. Reinstall the side panel. 31 A Open SV520 To remove a 3. 5" storage device: 1. 6. Online Manual Open the front panel door and remove the side panels. See "Opening the housing panels" on page 25 for more information. Use a Phillips screwdriver to remove the screws located on the right side of the plastic casing. Again, use a Phillips screwdriver to remove the screws located underneath the storage device. Reinstall the side panel. A Open 32 SV520 1. 4. 3 Installing and Removing a 5. 25" Device Drive 5. 25-inch device into the drive bay. 3. Online Manual You may install a CD-ROM, digital-audio tape (DAT), hard disk, diskette drive or any other Open the front panel door and remove the side panels. See "Opening the housing panels" on page 25 for more information. Attach the driver rail to one side of the plastic casing and secure it with two screws. See "Removing drive bay covers" on page 28. 33 A Open SV520 4. 6. Connect the power cable and signal cables to the external devices. Reinstall the side panels. A Open 34 SV520 To remove a 5. 25" storage device: 1. Disconnect the power and signal cables. Online Manual Open the front panel door and remove the side panels. See "Opening the housing panels" on Use a Phillips screwdriver to remove the screws located on the right side of the storage device. Reinstall the side panel. 35 A Open SV520 Online Manual 1. 5 Installing a Hot-Swap Cage (Optional) The hot-swap cage occupied four drive bays. For more information about the backplane board, please refer to "HSC6 Jumpers and Connectors" on page 22, . The HSC6 hot-swap cage includes the following components: · · · · · · One hot-swap cage (with back plane board attached) Six hard disk drive trays Three hot-plug fan-sink modules One SCSI terminator Two SCSI cables One I C cable. 2 A Open 36 SV520 1. 5. 1 Installing a HSC6 Hot-Swap Cage To install the hot-swap cage into the housing: 1. [. . . ] Close the chassis panel and restart the system. To change a front hot-swap housing fan: A Open 52 SV520 1. page 25 for more information. Online Manual Open the front panel door and remove the side panels. See "Opening the housing panels" on See which of the fan is defective. Insert your forefinger into the grasp hole and use your thumb to press the latch to release the defective fan. [. . . ]