User manual AOPEN AP5VM-ORG

[. . . ] AP5VM User's Guide Printed in Taiwan PART NO. : 49. 87530. 021 DOC. NO. : AP5VM-3-E9711E AP5VM Mainboard User's Guide Document Number Model and Revision Manual Version Release Date : AP5VM-3-E9711E : For AP5VM revision 2. xx and 3. xx : English, version E : Nov 13, 1997 More help for latest information: Taiwan USA Europe http://www. aopen. com. tw http://www. aopen-usa. com http://www. aopenamerica. com http://www. aopen. nl Copyright Copyright © 1997 by this company. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/television technician for help. Notice 1: The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Notice 2: Shielded interface cables, if any, must be used in order to comply with emission limits. iv Purpose and Scope This manual tells how to install and configure the system board. Organization Chapter 1, Overview, covers the introduction and specifications of the system board. Chapter 2, Hardware Installation, describes hardware jumpers, connectors and memory configuration. Chapter 3, AMI BIOS, explains the system BIOS and tells how to configure the system by setting the BIOS parameters. Chapter 4, Installing System Component, includes 3D drawing and step by step procedures for first time DIY user to install the system board, CPU, SIMM/DIMM, cable and add expansion cards. Appendix A, Jumper Table Summary, gives you a tabular summary of the jumper settings discussed in Chapter 2. Appendix B, Frequently Asked Question, collects most frequently asked question of this product. Appendix C, Troubleshooting Guide, includes first aid information you need if you meet trouble, the WWW address and worldwide service telephone/fax are also included. [. . . ] Important: Reminds you to take specific action relevant to the accomplishment of the procedure at hand. Tip: Tells how to accomplish a procedure with minimum steps through little shortcuts. vi Contents Chapter 1 Overview 1. 1 Chapter 2 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 Hardware Installation 2. 1 2. 2 2. 2. 1 2. 2. 2 2. 2. 3 2. 2. 4 2. 2. 5 2. 2. 6 2. 3 2. 3. 1 2. 3. 2 2. 3. 3 2. 3. 4 2. 3. 5 2. 3. 6 Jumper and Connector Locations. . . . . . . 2-2 Jumpers. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4 Setting the CPU Voltage. . . . . . . . . . . . . . . . . . . 2-5 Selecting the CPU Frequency. . . . . . . . . . . 2-9 Disabling the Onboard Super I/O Controller. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-12 Disabling the PS/2 Mouse Function. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-13 Clearing the CMOS. . . . . . . . . . . . . . . . . . . . . . . . . 2-14 Selecting the DIMM Type. . . . . . . . . . . . . . . . 2-15 Connectors. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-16 Power Cable. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-16 CPU Fan. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-17 PS/2 Mouse. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-17 Serial Devices (COM1/COM2). . . . . . . 2-18 USB Device (optional). . . . . . . . . . . . . . . . . . . . 2-19 Floppy Drive. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-20 vii 2. 3. 7 2. 3. 8 2. 3. 9 2. 3. 10 2. 3. 11 2. 3. 12 2. 4 Chapter 3 Printer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-20 IDE Hard Disk and CD ROM. . . . . . . . . . . 2-21 Hard Disk LED. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-23 Panel Connector. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-24 Keyboard. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-26 IrDA Connector. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-27 Configuring the System Memory. . . . . . . 2-28 AMI BIOS 3. 1 3. 2 3. 2. 1 3. 2. 2 3. 2. 3 3. 2. 4 3. 2. 5 3. 2. 6 3. 3 3. 4 3. 5 3. 6 Entering the AMI BIOS Setup. . . . . . . . . . . . . . . 3-1 Setup Menu . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-3 Standard Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-3 Advanced Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-7 Chipset Setup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-12 Power Management Setup . . . . . . . . . . . . . 3-16 PCI/PnP Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-19 Peripheral Setup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-22 Security Setup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-24 Utility Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-27 Default Setup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-28 Exiting Setup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-30 viii 3. 7 3. 8 Chapter 4 Onboard NCR SCSI BIOS . . . . . . . . . . . . . . . . . . . 3-31 AMI Flash Utility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-31 Installing System Component 4. 1 4. 1. 1 4. 1. 2 4. 1. 3 4. 1. 4 4. 2 4. 3 4. 4 4. 4. 1 4. 4. 2 4. 4. 3 4. 4. 4 4. 4. 5 4. 4. 6 4. 4. 7 4. 4. 8 Installing Memory Module. . . . . . . . . . . . . . . . . . . . 4-1 Installing a SIMM. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-2 Removing a SIMM. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-2 Installing a DIMM. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-3 Removing a DIMM. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-4 Installing or Upgrading a CPU . . . . . . . . . . . . . 4-4 Installing the System Board. . . . . . . . . . . . . . . . . 4-5 Accesory Bracket and Cables. . . . . . . . . . . . . . 4-6 Baby AT (PS/2) Power Cable. . . . . . . . . . . 4-7 Serial Port Bracket (COM1/COM2). . 4 -7 PS/2 Mouse Bracket. . . . . . . . . . . . . . . . . . . . . . . . . 4-8 Printer Bracket. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-8 USB Bracket. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-9 Floppy Cable. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-9 IDE Cables for HDD and CDROM. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-10 Front-panel Switch and LED Cables. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-10 ix 4. 5 Installing Add-on Cards . . . . . . . . . . . . . . . . . . . . . 4-11 Appendix A Appendix B Appendix C Appendix D Jumper Table Summary Frequently Asked Question Troubleshooting AOpen Best Products x [. . . ]