User manual AMICA 608GE3.33ZPTSNQ

[. . . ] After reading the instruction manual, operating the cooker will be easy. Before being packaged and leaving the manufacturer, the cooker was thoroughly checked with regard to safety and functionality. Before using the appliance, please read the instruction manual carefully. By following these instructions carefully you will be able to avoid any problems in using the appliance. [. . . ] 00" will start flashing in the display field upon connection to the power supply. ), remove any stains and wash carefully; the heating zones of the hob should be heated for around 4min. To clean the oven, only use a cloth well rang out with warm water to which a little washing-up liquid has been added. The timer can be activated at any time, regardless of the status of other functions. The timer can be set for from 1 minute to up to 23 hours and 59 minutes. To set the timer you should: After connection to the mains or reconnection after a power cut the display shows flash 0. L Press and hold OK (or simultaneously press < and >) until you will see on the display and the dot below the symbol is flashing, L Press < or > within 7 seconds to set the current time. To store the new time setting, wait approximately 7 seconds after time has been set. Press button OK, < or > in order to switch off the signal, the signal function will go out and the display will show the current time. If the alarm signal is not turned off manually, it will be turned off automatically after approx. To do this press < and >, simultaneously and adjust the current time while the dot below the symbol is flashing. The tone of the timer beeps may be changed as follows: Press buttons < and > simultaneously, select "tone" function with the OK button, the display panel will start to blink: With the < button press the appropriate buttons from OK to > to select the option you wish. Choice of cookware Choose a pan with a diameter that is at least as large as the heating zone. If the heating zones and pans are solied it is impossible to make full use of the heat. The level of heat can be adjusted gradually by turning the appropriate knob to the right or left. Grilling meat, fish Zone heating indicator If the temperature of a heating zone exceeds 50°C this is signalled by an indicator which lights up for that zone. When the heating indicator lights up it warns the person using the cooker against touching a hot heating zone. For about 5 to 10 minutes after a heating zone is switched off it will still have residual heat that can be used, for example to warm up or keep dishes warm without switching on another heating zone. Oven with automatic air circulation (including fan) The oven can be warmed up using the bottom and top heaters, as well as the grill. Operation of the oven is controlled by the oven function knob ­ to set a required function you should turn the knob to the selected position, as well as the temperature regulator knob ­ to set a required function you should turn the knob to the selected position. 50 The oven can be switched off by setting both of these knobs to the position ""/"0". ) the oven will only be switched on after the temperature has ben set by the temperature regulator knob. [. . . ] Set all control knobs to the position ""/"0" and disconnect the mains plug, Unscrew and wash the lamp cover and then wipe it dry. Unscrew the light bulb from the socket, replace the bulb with a new one ­ a high temperature bulb (300°C) with the following parameters: - voltage 230 V - power 25 W - thread E14. Screw the bulb in, making sure it is properly inserted into the ceramic socket. Do not use any abrasive agents, harsh detergents or abrasive objects for cleaning. [. . . ]