User manual AMERICAN DJ COMMANDER

[. . . ] Before the device is switched on, all fader and volume controls should be set to 0 (zero) or minimum position. Damages caused by manual modifications to the device or unauthorized operation by unqualified persons are not subject to warranty. For maintenance and/or service, contact an authorized American DJ® dealer. XDM-3633 User Instructions page 3 Operating Determinations When installing this mixer, please make sure that the device is not exposed to extreme heat, moisture or dust!Do not operate the mixer in extremely hot (more than 30° / 100°F) or extremely cold (less than 5°C / 40°F) surroundings. [. . . ] The selectors for AUX1/PHONO1, AUX2/PHONO2 and AUX3/PHONO3 are on the rear panel (41). MIC 3 1/4" stereo input is also on the rear panel of the mixer (36). (4) GAIN CONTROL - Used to set the level of the input signal for its designated channel. (5) PFL / CUE BUTTONS - Use the PFL button to engage the input level of each channel. (6) PFL DISPLAY - When PFL button is on, LEDs show the level of the channel currently being cued. (8) EFFECTS BUTTON - Individual send and receive for CHANNELS 1 - 4, MIC 1 & MIC 2. (9) MIC 1 & MIC 2 JACKS - Designed with NeutrikTM connection - connect microphones with 1/4" (6. 3mm) jack plug or XLR plug. (10) MIC EQ - Use these controls to fine tune the signal for MIC 1 & MIC 2. Increase the LOWs, MIDs & HIs by turning the respective control to the right. (11) AUTO MUTE / TALKOVER SWITCH - Use this switch when using the microphone. When AUTO MUTE switch is activated and the DJ begins speaking into the microphone, all other channels will mute (turn off). As soon as the DJ stops speaking, all channels will be restored to their original levels. If the switch on MIC 1 is set to TALKOVER, all signals but the microphone level are attenuated (or drop) by -15dB when the microphone is voice-activated. As soon as the DJ stops speaking, the output level is reset to the original level. After speaking, the switch should be manually set back to the OFF position. XDM-3633 User Instructions page 5 Functions (Front Panel) Cont. (12) TALKOVER LEVEL - Adjust the TALKOVER volume on MIC 1. (13) MIC 1 / MIC 2 LEVEL FADER - Adjusts the microphone volumes of MIC 1 and MIC 2. MIC 3 levels may be adjusted with the CHANNEL 4 FADER (17) when the CH-4 LINE 5/LINE 6/MIC 3 SWITCH is set to MIC 3. (15) CHANNEL ASSIGN SWITCH - Used to select which channel is to be mixed with another. (16) FEATHER FADERTM CROSSFADER - Mixes the signals of one channel with another. With the CHANNEL ASSIGN SWITCHES (15), you can choose which channel is to be mixed with another. EXAMPLE: Set the left CHANNEL ASSIGN SWITCH to channel 1 and the right switch to channel 2 in order to mix the signal of channel 1 with channel 2. [. . . ] The PHONO /AUX SELECTOR SWITCH gives the DJ the possibilities of 3 extra inputs lines (ie. (42) INDEPENDENT LIGHT CONTROL - Buffered audio output for light controllers that can use external input. (45) ZONE 1 & ZONE 2 OUTPUTS - Left & Right RCA output jacks controlled by the ZONE 1 & ZONE 2 (24, 25, 26) controls on the front panel. (46) SEND & RECEIVE EFFECTS - Left & Right 1/4" stereo jacks for SEND (27) & RECEIVE (28) EFFECTS. [. . . ]