User manual ALTEC LANSING PT8051

[. . . ] This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] The PT8051 creates a realistic surround sound experience from just two units. 4 GHz wireless transmission system that eliminates the need to run wires to the rear surround speakers. While placement is less critical than similar systems, the following general guidelines should be followed where possible to ensure best sound quality: · Avoid placement where furniture or other items would obstruct the grill area. Center the PT8051 below the TV so that dialogue appears to be coming from it. The maximum allowable distance between the main and rear surround units is approximately 40 feet (12. The rear surround unit should be placed behind the primary listening position to maximize the surround sound effects from the system. For maximum sound quality it should be placed at or near ear level when they are seated in the listening position. Warning: Do not insert the PT8051's power plug into a wall outlet until you connect other sources such as your TV, DVD player, satellite tuner or alternate audio source. The PT8051 is designed to connect external components such as your DVD player, satellite TV tuner, cable TV tuner, VCR, game console and TV. In cases where there are both digital and analog outputs such as a DVD player we recommend using the digital output to ensure best sound quality and optimal surround sound reproduction. Be sure to leave adequate ventilation space ­ at least 2 inches (50mm) above both the main and rear surround units. We do not recommend installing this unit so that it is directly on the floor. Be sure to secure it where it will not fall and where it is out of the reach of children. Do not install the main or rear surround units directly above a cathode-ray tube (CRT) TV as stray magnetic fields may distort the TV. The PT8051 can accept digital input signals using standard, commercially available optical or coaxial cables. If you have connected your DVD player using an optical or coaxial digital cable you can use this input for another device. Use an optical cable to connect the OPTICAL IN (AUX) jack on the PT8051 to the optical output jack on a digital audio source such as a game console or digital video recorder. Note: When connecting a DVD player we recommend using the coaxial input found on the rear of the PT8051. However, if your DVD player only has an optical output it can be connected to the AUX input. Using the supplied A/V cable, connect one yellow end to connect the VIDEO OUT on the PT8051 and the other yellow end to the video input jack on the TV. This connection allows you to view the onscreen display (OSD) on your TV screen when the corresponding input is selected. Ensure that the cables are connected correctly observing left (white) and right (red) connections at both the PT8051 and the source device. [. . . ] Note: If you want to leave the setup mode, press the device button (TV, SAT/CAB, DVD, etc. If you do not press any buttons after 10 seconds, SETUP MODE exits automatically. If you cannot find a code number from the Preprogrammed Remote Control Codes section of this manual that matches your equipment, the PT8051 remote can search its database for a suitable control code from the codes programmed into the remote. the PT8051 remote control will find the best possible component code for any audio source. [. . . ]