User manual ALTEC LANSING MR94B HF HORN

[. . . ] · Do not install the refrigerator where the temperature will go below 50 ºF (10 ºC). FLOORING For proper installation, this refrigerator must be placed on a leveled surface of hard material that is the same height as the rest of the flooring. This surface should be strong enough to support a fully loaded refrigerator, or approximately 359lbs (165kg). To protect the finish of the flooring, cut a large section of the cardboard carton and place it under the refrigerator where you are working. [. . . ] This button serves two purposes: 1) To turn the door open alarm on and off If the door alarm is set to On, an alarm beeps if any refrigerator door is left open for more than three minutes. You can turn it off by touching and then releasing the Alarm/ Hold button. After you replace the water filter, touch and hold this button for 3 seconds to reset the water filter life indicator. Touching this button turns on the Dispenser LED lamp (under the display) in continuous mode so that it stays on continuously. If you want the Dispenser lamp to come on only when some one uses the dispenser, touch this button to turn the continuous mode off. Touch and hold this button for 3 seconds to switch the temperature units between °C and °F. You can set the temperature between 34 °F and 46 °F (between 7 °C and 1 °C). Touch and hold this button for 3 seconds to decrease the time needed to cool products in the Refrigerator. It can be helpful if you need to quickly cool easily spoiled items or if the temperature in the fridge has warmed dramatically (For example, if the door was left open). Also, pressing this button for 3 seconds turns on Child Lock which locks the display panel and dispenser buttons so the buttons can not be used. The Child Lock icon lights up to indicate you've activated the Child Lock function. The temperature control process for the Fridge works just like the Freezer process. After a few seconds, the Fridge will begin adjusting towards the newly set temperature. This will be reflected in the digital display. Recommend Temp (Fridge) : 38 °F (3 °C) Names and basic functions NAMe OF eACH COMPONeNT 1. 6. Interlocking switch Light FF Ice-Maker Foldable-Shelf Slide-Shelf Vertical Hinged Section 7. 12. Vegetable & Fruit Drawers FZ Ice-Maker (on some model) Tilting Pocket Ice Bucket Door Closer Dairy Compartment 13. 18. Tempered glass shelves Door Bins Quick-Space Glass Shelf Cool Select Pantry PLUS Auto Pull Out Drawer Freezer Drawer Bin Troubleshooting PROBLEM The refrigerator does not work at all or it does not chill sufficiently. · Check if the set temperature on the digital display is warmer than the freezer or fridge inner temperature. · Is the refrigerator in direct sunlight or located near a heat source?· Is the back of the refrigerator too close to the wall, preventing proper ventilation?· · · · Check if the set temperature on the digital display is too low. Did you store the food which is juicy in the coldest part of the refrigerator? [. . . ] · If it sounds as if something is hitting something else inside the refrigerator, this is normal. · Some heat is normal as anti-condensators are installed in the vertical hinged section of the refrigerator to prevent condensation. · · · · Did you wait for 12 hours after installation of the water supply line before making ice?Try setting the freezer temperature lower. The cabinet-door sealing area of the appliance is hot and condensation is occurring. [. . . ]