User manual ALTEC LANSING M400 SPEAKER SYSTEM

[. . . ] 12 9 3 6 If you have further questions or damaged accessory parts, contact us at 1-800-ALTEC LANSING (726-7864) 6.  Water dispenser dripping (On some models) • f the water line is not inserted into the coupler I properly, air could penetrate into the water line causing water dripping from the water dispenser. €¢  AUTION : Insert the water line into the coupler comC pletely and slide in the clip at the end of the coupler. [. . . ] For details, refer to the user manual “Using the control panel. Moving and Installing •  hen installing, servicing or cleaning behind the W refrigerator, be sure of the following: •  o protect your floor's finish when moving the T refrigerator, cut a large section of the cardboard carton and place under the refrigerator where you are working. €¢  ull the unit straight out and push back in P straight after finishing. Slow Ice cube freezing •  heck if the ice bucket is completely C inserted. (On some models) •  reezer temp may not be enough; F set it to -2ºF(-19ºC) or lower.  Small or bubbled ice cubes or Slow water dispensing • f the water filter is clogged, small or bubbled ice I cubes may be produced.  he Water Line must be fully Inserted to the center T of transparent coupler to prevent water leakage from the dispenser. €¢  lso, when you put room temperature or warmer A food into your refrigerator, it may need an additional 24 hours for the fridge to reach the set temperature. Control Lever Flat-blade screw driver(-) •  pen the freezer drawer to gain an access to the O adjustable hinge pin.  Moisture forms on outside/inside of refrigerator •  ipe off the condensation with a dry towel (This W may occur during hot and humid seasons. ) • f the condensation occurs on the doors, turn off I the Energy Saving function. €¢ f you open the doors frequently or for too long, it I may cause moisture inside the fridge. RAISE • f you need to add more height to the door, insert I the provided snap rings. Food stored in refrigerator is frozen • f food with too much moisture is stored near the I cooling vents, it may get frozen. [. . . ] Food stored in refrigerator is frozen • f food with too much moisture is stored near the I cooling vents, it may get frozen. €¢  or details, refer F to the user manual “Adjusting the level” 5.  Water is not cool enough (On some models) •  he first glass of water may not be cold enough T because the stored water in the water valve has not cooled completely. [. . . ]