User manual ALTEC LANSING FX2020 INSTALLATION

[. . . ] Check the compressor label on the rear of the appliance and the rating label inside the fridge to see which refrigerant is used for the refrigerator. · In case of R600a refrigerant, this gas is natural gas with high environmental compatibility that is, however, also combustible. When transporting and installing the appliance, care should be taken to ensure that no parts of the refrigerating circuit are damaged. · Refrigerant squirting out of the pipes could ignite or cause an eye injury. [. . . ] Unscrew the nut 1 from the lower hinge until it reaches the upper end of the bolt 2 . Screw Driver Leg 3 Wrench 2 Bolt 1 Nut Leg Screw Driver Refer to the next section for the best way to make very minor adjustments to the doors. When you release the nut 1 , make sure that you use the Allen wrench provided 3 to loosen the bolt 2 in a counter-clockwise direction. Adjust the height difference between the doors by turning the bolt 2 clockwise or counter clockwise . , the door will MAKING MINOR ADJUSTMENTS TO THE DOORS Remember, a levelling refrigerator is necessary for getting the doors perfectly even. If you need help, review the previous section on levelling the refrigerator. 3. After adjusting the doors, turn the nut 1 until it reaches the lower end clockwise of the bolt, then tighten the bolt again with the wrench 3 to fix the nut in place 1 . If you do not secure the nut firmly, the bolt may release. 10_ setting up CHECKING THE WATER DISPENSER LINE A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote better health, the Samsung water filter removes unwanted particles from your water. In order for the icemaker to operate properly, water pressure of 138 ~862 kPa is required. Under normal conditions, a 170 cc paper cup can be filled in 10 seconds. If the refrigerator is installed in an area with low water pressure (below 138 kPa), you can install a booster pump to compensate for the low pressure. This Function must be activated before putting large stuff in freezer compartment at least 24 hours before. Press the Freezer button to set the freezer to your desired temperature. When Ice Off blinks on the display panel, reinsert the bucket and/or make sure it's installed properly. When you change the filter, press and hold this button for 3 seconds to reset the filter schedule. Press the Fridge button to set the fridge to your desired temperature. Power cool will be on the display after 1°C By pressing this button, all buttons will be locked. If you are going on vacation or business trip or you do not need to use the refrigerator, press and hold this button for 3 seconds. The temperature in the fridge will be around 15°C and the freezer will work normally. VACATION This icon will light up when you activate the "Vacation" feature. If you are going on vacation or business trip or you do not need to use the refrigerator, press and hold the Child Lock button for 3 seconds. The temperature in the fridge will be around 15°C and the freezer will work normally. The refrigerator section should be emptied. ALARM This icon will light up all the time. [. . . ] After opening beyond a certain point, the door will "catch" and remain open. When the door is ajar ahead of the catch that allows it to stay open, it will close automatically. 18_ operating troubleshooting PROBLEM The refrigerator does not work at all or it does not chill sufficiently. · Is the temperature control on the display panel set to the correct temperature?· Is the refrigerator in direct sunlight or located too near a heat source? [. . . ]