User manual ALTEC LANSING 9849-8B SPEAKER SYSTEM

[. . . ] DR Ready(WF461AS*) The DR-READY function determines the value of and determines whether to run or not accordingly depending on the power consumption data from the server, if a modem is connected to the Washer and the Washer is connected with the server. PureCycle™(Tub Cleaning cycle) Clean your drum with one button!This Pure Cycle is specially designed to remove detergent residue and dirt buildup in the tub, diaphragm, and on the door glass without the need for special chemical detergents. With inside holes 36% smaller than those of conventional drums, the diamond drum prevents fabrics from sticking out through the holes and consequently being damaged. [. . . ] Once you have activated the Child Lock function, the control panel cannot be activated, preventing children from playing with the washer. ACTIVATING/DEACTIVATING Press and hold both the Soil Level and Signal buttons simultaneously for approximately 3 seconds. €¢ When you activate the Child Lock function, the door locks and the “Child Lock [ ]” lamp illuminates. €¢ If you press the Start/Pause button after you have activated the Child Lock function , none of the buttons will work except for the Power button. €¢ If you press a button when the buttons are locked, the “Child Lock [ ]” lamp blinks. 18_ Washing a load of laundry 9849-8B SPEAKER SYSTEM-03016A-07_EN_v1. Indd Sec11:18 2012-05-09 2:17:25 Pausing the Child Lock function When the door is locked or the buttons are locked by the Child Lock function, you can pause the Child Lock operation for 1 minute by pressing and holding both the Soil Level and Signal buttons simultaneously for approximately 3 seconds. €¢ If you pause the Child Lock mode temporarily, the door lock is released for 1 minute for user ]” lamp blinks. During this period, the “Child Lock [ • If you open the door after the minute is over, an alarm sounds for up to 2 minutes. €¢ If you close the door within the 2 minutes, the door is locked and the Child Lock function is reactivated. If you close the door after the 2 minutes, the door is not locked automatically and no alarm sounds. If for any reason the wash cycle is interrupted and the washer does not finish the cycle, it will not program in the settings for later use. washing a load of laundry _19 9849-8B SPEAKER SYSTEM-03016A-07_EN_v1. Indd Sec11:19 2012-05-09 2:17:25 washing a load of laundry Override This is the function that can operate the unit regardless of the DR level. Setting/Releasing To turn the Override function on or off, press and hold bo¬th the Temp and Time buttons for 3 seconds. The Override function setting is reset when the cycle is complete or the power is turned off. DR-Ready Operations and Display Method Operations according to the DR Level DR Level DR level 0 DR level 1 DR level 2 DR level 3 Operation N/A N/A Start Delay: Up to 3 hours or the user-configured period of time. At least 50% N/A washer Normal operation Normal operation 1) Heater is turned off. 2) Normal operation except for the heater 1) Switches to the pause state. DR level 4 Override • • • • • Normal operation Normal operation regardless of the DR level. The Override function can be set to on or off when the power is on (when the button is pressed and held for 3 seconds). The Override function setting is reset when the cycle is complete or the power is turned off. [. . . ] warranty service can only be performed by a ALTEC LANSING authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to ALTEC LANSING or ALTEC LANSING’s authorized service center. ALTEC LANSING will provide in-home service during the warranty period at no charge, subject to availability within the contiguous United States. To receive in-home service, product must be unobstructed and accessible to the service agent. [. . . ]