User manual ALTEC LANSING 9444B POWER AMPLIFIER SERVICE

[. . . ] Because the following instructions cover various models, the characteristics of your refrigerator may differ slightly from the refrigerator described in this manual. If you have any question, contact us at 1-800-ALTEC LANSING or find help and information online at www. WARNING SEVERE WARNING SIGNS FOR INSTALLATION -•• •• -- Important safety symbols and precautions: WARNING •• -•• •• •• •• Hazards or unsafe practices that may result in severe personal injury or death. Hazards or unsafe practices that may result in minor personal injury or property damage. [. . . ] Compression Nut (1/4”) (Assembled) Plastic Tubing (Assembled) Compression Fitting (Assembled) Molded end(Bulb) Compression nut (B) (1/4”) (Not supplied) Ferrule (Not supplied) 222 Locate the nearest cold water drinking line and install the pipe clamp and shut off valve. Cold water line Pipe clamp Copper tubing or (Not supplied) Plastic tubing (B) (Not supplied) Household water supply line Shut off valve 111 Connect the household water line to the assembled compression fitting. -- If you are using copper tubing, slip the compression nut ( B ) (not supplied) and ferrule (not supplied) on the copper tubing (not supplied) as shown. -- If you are using plastic tubing ( B ) , insert the molded end (Bulb) of the plastic tubing ( B ) into the compression fitting. 29 9:28:42 AM cAuTION Do not use without the molded end (Bulb) of the plastic tubing ( B ). Completing the set up Now that you have your new refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your refrigerator should be fully operational. 111 Make sure your refrigerator is in an appropriate location with reasonable clearance between it and the wall. 222 Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors. 333 Set the Temperature control to the coldest temperature and wait for an hour. The freezer will get slightly chilled and the motor will run smoothly. In Cooling Off Mode, the refrigerator works but doesn’t make cool air. To cancel this mode, press the Power Freeze and Freezer buttons at the same time for 5 seconds until a “Ding-dong” sound is heard and the unit will now cool. 29 9:28:42 AM Changing the water filter To reduce risk of water damage to your property DO NOT use generic brands of water filters in your ALTEC LANSING Refrigerator. ALTEC LANSING will not be legally responsible for any damage, including, but not limited to property damage caused by water leakage from use of a generic water filter. ALTEC LANSING Refrigerators are designed to work ONLY WITH ALTEC LANSING Water Filter. The Filter light turns red to let you know when it is time to change your water filter cartridge. To give you time to get a new filter, the red light comes on just before the (Red) capacity of the current filter runs out. Changing the filter on time provides you with the freshest, cleanest water from your refrigerator. WARNING 4 555 After removing the old water filter and installing a new reset the indicator by pressing the “Fridge” and “Power Cool” button simultaneously for about 3 seconds. For a replacement water filter, you can visit your local home Improvement center or contact the Samsung Parts distributor. Be sure the replacement water filter has the ALTEC LANSING logo on the box and on the water filter. [. . . ] To receive warranty service, the purchaser must contact Samsung for problem determination and service procedures. warranty service can only be performed by a Samsung authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to Samsung or Samsung authorized service center. Samsung will repair or replace any part found to be defective, at our option and at no charge as stipulated herein, with new or reconditioned parts during the limited warranty period specified above. [. . . ]