User manual ALTEC LANSING 9444A POWER AMPLIFIER

[. . . ] Indd 1 2012-03-02 9:28:47 ALIGNMENT AND ADJUSTMENTS WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. GENERAL ERROR FUNCTION NO 1 Error Code nd Diagnostic Code Error Image nd Description The water level fails to drop below the Reset Water Level within 15 minutes. 2 LO LO 3 nF nF When the filling Continues for Go to “ No Water Fill” more than 40 minutes or there is no Troubleshooting Section. 4 FL FL 5 LE LE A water level lower than the Reset water level (25. [. . . ] Quick Spin Test Mode: As it enters into the Quick Spin Test Mode, it starts spinning and reaches to its maximum RPM. Once the Spin speed reaches the maximum RPM, the speed drops immediately. to hold Quick Spin Test Mode (entering Hold Speed Mode) , press the Start/Pause button. If the Start/Pause button is pressed during Quick Spin Test Mode, it will stop accelerating and hold its spinning speed for 10 minutes before going back to Quick Spin Test Mode. Also, to cancel the hold and allow Quick Spin Test Mode to continue, press the Pre Wash + Soil Level Keys together for 3 seconds. If you hold down the Pre Wash + Soil Level Keys for three (3) seconds when the washing machine is not in Hold Speed Mode, Quick Spin Mode is exited and Service Mode is restored. Indd 8 2012-03-02 9:28:48 ALIGNMENT AND ADJUSTMENTS WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. cycle Count Check Mode Definition of Cycle Count Check Mode: - Cycle Count Check Mode is to tally up the number of washings. How to Enter: - To enter the Cycle Count Check Mode, press the Signal Key during Service Mode. When the Signal key is pressed, the total number of washings will light up and a signal LED will glow. (For normal and Continuous Run cycles, the count is carried out at the end of the cycles. When turning it in the opposite direction, it shows the diagnostic codes in the reverse order. Ex) When it stops at d5 and turns backward, it shows from d4 down to “d”. Indd 12 2012-03-02 9:28:49 ALIGNMENT AND ADJUSTMENTS WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. Demo Mode - Demo mode is entered when the Steam + Signal + PureCycle buttons are held down for five (5) seconds simultaneously in the power on state. - When entering Demo mode, the buzzer rings three (3) times and “- - - -” is displayed on the 7 segment display and all other LEDs are turned off. (Initial Demo mode) - Demo mode consists of WASH , SPIN and LED modes. - If the Temp button is pressed during the initial Demo mode, “WASH” blinks on the 7 segment display and the washing machine enters WASH mode. - If the Start/Pause button is pressed in WASH mode, the door is locked (Door Lock) and the motor rotates left and right at 45 RPM in a 7 sec on and 3-sec off cycle. After the five (5) minutes have elapsed, “- - - -” is displayed on the 7 segment display and the initial Demo mode is maintained. - If the Start/Pause button is pressed during a WASH mode operation, “- - - -” is displayed on the 7 segment display and the initial Demo mode is maintained. - If the Spin button is pressed in the initial Demo mode, “Spin” blinks on the 7 segment display and the washing machine enters SPIN mode. [. . . ] ) No Key Operation • Option and Function buttons respond differently according to each cycle. To exit, hold down Soil Level Key and Signal Key simultaneously until it sends out a beeping sound. € When “End“ illuminates on the display, only Power button works. For safety reasons, the washer does not tumble or spin with the door open. [. . . ]