User manual ALTEC LANSING 515-8HHP LF SPEAKER

[. . . ] PROFE S S IONA l 515-8HHP 515-16HHP High Efficiency 15" Low Frequency Speaker FREQUENCY RESPONSE 1, 2 40 Hz ­ 5 kHz HIGHEST RECOMMENDED CROSSOVER FREQUENCY 2. 5 kHz SENSITIVITY 3 104 dB SPL POWER HANDLING 4 200 W continuous; 800 W peak MAXIMUM OUTPUT (1 m) 5 133 dB SPL TRANSDUCER COMPONENTS LF: 1 x 15 inch, high efficiency, low frequency driver IMPEDANCE 7 Nominal: 8. 0 Ohms or 16 Ohms Minimum: 7. 9 Ohms or 15. 8 Ohms at 600 Hz HARMONIC DISTORTION 8 THD: 0. 85% INPUT CONNECTIONS 1 x 2 position barrier strip with 0. 250 in. blade type terminals FINISH Dark gray enamel REPLACEMENT LF CONE KIT R515-8HP or R515-16HP DIMENSIONS Outside Diameter: 16. 0 in. [. . . ] Their nominal impedance shall be 8 Ohms and 16 Ohms, with a minimum impedance of 7. 9 Ohms and 15. 8 Ohms at 600 Hz. The magnetic gap of these drivers shall have a flux density of 1. 5 T, resulting from an 8. 25 lbs. Their nominal free-air cone resonance shall be 37 Hz and their voice-coil shall be 3 inches (76 mm) in diameter of edge-wound aluminum ribbon. The loudspeakers shall have dimensions of 16 inches (406 mm) in diameter and 6. 69 inches (170 mm) in depth, and shall weigh 30 lbs. The low frequency loudspeakers shall be Altec Lansing models 515-8HHP and 515-16HHP. FREQUENCY RESPONSE AND IMPEDANCE MAGNITUDE OF 515-16HHP IN 828G As we are continually striving to improve Altec Lansing products, specifications are subject to change without notice. Please visit www. altecpro. com for the latest information on Altec Lansing Professional products. SPECIFICATION NOTES 1 The frequency response of the loudspeaker system is measured at a distance of no less than 3 meters to obtain full range data. The level is then corrected to be equivalent to a 2. 83 V 1 m measurement. A near field measurement of the loudspeaker system is performed for frequencies below 500 Hz. This data is then combined with the full range measurement to give an accurate composite frequency response curve. 2 The limits of the frequency response are referenced to -10 dB of the systems rated sensitivity in a 828G vented enclosure. [. . . ] · One paragraph A&E Specifications in . doc format PROFE S S IONA l © 2003 Altec Lansing Professional 1000 W. Wilshire Blvd. , Suite 362 Oklahoma City, Oklahoma 73116 Phone: 1-405-848-3108 · Fax: 1-405-848-3217 Web: www. altecpro. com · Email: proinfo@alteclansing. com AW1074 REV02 [. . . ]