User manual ALTEC LANSING 418-8H LF SPEAKER

[. . . ] Do not cover the unit with a dust cover, cloth or plastic film while the power is on. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. The socket-outlet shall be installed near the equipment and shall be easily accessible. Do not install your unit in areas that are: · Subject to extreme temperature or humidity changes, e. [. . . ] Check the following hardware and software requirements in order to install the software. 0 (ServicePack 5 or later)*3, Windows 2000 Professional, Windows XP Professional*3, Windows XP Home Edition*3 Display 800 x 600dots (SVGA) display with 256 colours (or better) Hard disk free space 150MB or more Other requirement An environment on which any of the operating systems listed for hardware above can fully operate *1 Compatible with Windows 98, Windows Me, Windows 2000 Professional, Windows XP Professional or Windows XP Home Edition preinstalled model with USB interface equipped as standard. *3 The administrator's authorisation is required to install this software using this installer. The following table shows the drivers and software that can be installed for each version of Windows and interface connection method. MFP Driver Printer driver/ Print Status Scanner driver Window Users of Windows 98/Me/2000/XP who will use the USB interface connection Users of Windows 98/Me/2000/XP who will use the parallel interface connection Windows 95/NT 4. *1 When the unit is connected through the parallel port, the Print Status Window can only be used when the parallel port is set to ECP mode. To set the parallel port mode, refer to your computer manual or ask the manufacturer of your computer. *2 Sharpdesk can be installed when using a parallel interface connection, however, the unit's scanner function cannot be used. Is there another GDI printer driver or a Windows Printing System printer driver already installed? operating system Windows XP Windows 98 Interface USB/ Parallel USB Parallel USB Windows Me Parallel USB Windows 2000 Windows 95/ NT 4. 0 Parallel Parallel Reference pages for how to install Installing onto Windows XP (USB/parallel interface) (p. When the "Choose Destination Location" window appears, click the "Next" button. When the "Select Program Folder" window appears, click the "Next" button. Click the "Finish" button when the message informs you that Setup is complete. Click the "Close" button when the message informs you that "Setup has finished". When the "Now connect the MFP interface cable to the PC" dialog box appears, click the "OK" button. After the installation, a message to restart your computer may be displayed. In this case, click the "Yes" button to restart your computer. If you are using Windows XP with the parallel interface, go to step 12. "ALTEC LANSING AR-xxxx" (where xxxx is the model name of your MFP) will appear in the "Found New Hardware Wizard" dialog box. When installation of the driver is completed, click the "Finish" button to finish the scanner driver installation. "ALTEC LANSING AR-xxxx" (where xxxx is the model name of your MFP) will appear in the "Found New Hardware Wizard" dialog box. [. . . ] You may not electronically transmit the Software from one computer to another or over a network. You may terminate this License at any time by destroying the Software and related documentation and all copies thereof. This License will terminate immediately without notice from ALTEC LANSING and/or ALTEC LANSING'S Licensors if you fail to comply with any provision of this License. Upon termination you must destroy the Software and related documentation and all copies thereof. [. . . ]