User manual ALTEC LANSING 1742A SIGNAL PROCESSING

[. . . ] Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. The answers to most setup and performance questions can be found in the Troubleshooting guide. You can also consult the FAQs in the customer support section of our Web site at www. [. . . ] PC AUDIO Connect the lime green audio input cable to your PC's sound card output jack (typically colored lime green and usually labeled "1" or "Main") as described in your PC/sound card documentation. ) Connect the lime green audio input cable to the line out of your portable device (if it has one) or to the device's headphone jack. Connect any audio source that has red (right) and white (left) RCA output jacks to the 1742A SIGNAL PROCESSING's red (right) and white (left) RCA input jacks. Note: For the clearest sound, try muting your TV's speakers when using the TV as an audio source. Check the owner's manual for your audio device for more information. We would like to thank you for purchasing the 1742A SIGNAL PROCESSING Powered Audio System. With the fusion of pro audio linearray and tri-amp technologies, the "In-Concert" TM 1742A SIGNAL PROCESSING uses three discrete amplifiers to power a total of twelve high performance fullrange micro drivers. To view other Altec Lansing Powered Audio Systems and accessories, please visit our website at www. Subwoofer Warning: The subwoofer is NOT magnetically shielded, so it must be kept at least 2 feet (0. 6m) from PC monitors, TV sets, computer hard drives or any other magnetic media (floppy disks, computer or audio tapes, etc. The subwoofer is non-directional, so it doesn' t need to be placed in any particular location. When using the hardwired controller, turn the master volume knob clockwise to increase the treble and counter-clockwise to decrease the treble. when using the remote , press and hold "+" button to increase the treble or press and hold the "­" button to decrease the treble. An LED will light up and move on the wired controller to indicate changing treble levels. the LED will reside in the far right position for maximum treble and in the far left position for minimum treble. It is important to note that while in stand-by mode the system continues to receive power. To completely shut down the 1742A SIGNAL PROCESSING, press the standby button on the hardwired controller or wireless remote and then unplug the unit from the wall. To use headphones with the system, plug them into the labeled jack on the side of the wired controller. When headphones are connected, both satellites and the subwoofer are muted. The satellite can be mounted to the wall using the key holes (top and bottom), or by using the threaded inserts on the rear of the satellite (threaded inserts require the purchase of a universal mounting kit. If this does not work, contact the Altec Lansing Consumer Support Department for further instructions. Disconnect and then reconnect the power adapter to both the wall outlet and the subwoofer. [. . . ] Plug another device into the same jack on the wall outlet to ensure the outlet is working. verify that the grey-colored DIN connector is firmly inserted into the DIN connector jack on the subwoofer. Verify that the subwoofer's AC power cord is plugged into both the wall outlet and subwoofer. Make sure these signal cables are inserted firmly into the correct jacks. [. . . ]