User manual ALTEC LANSING 1678C SIGNAL PROCESSING

[. . . ] (For information on proper installation, operation and use consult the manual supplied with the product. If you require a replacement manual, you may download a manual from www. ) Also, consequential and incidental damages are not recoverable under this warranty. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. [. . . ] If the provided plug does not fit into your outlet, consult an electrician for the replacement of the obsolete outlet. Protect the power cord from being walked on or pinched -- particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Disconnecting the power plug is the only way to completely remove power to the product and must be readily accessible at all times. Power source -- Use only power supplies of the type specified in the operating instructions or as marked on the appliance. If a separate power supply is included with this apparatus, do not substitute with any other power supply -- use only manufacturerprovided power supplies. Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. For service, refer to qualified service personnel, return to the dealer, or call the Altec Lansing service line for assistance. For products which incorporate batteries, please refer to local regulations for proper battery disposal. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Use one of the following two options to power your iM7BLK: The stand-by button can be used to turn the unit on and place the unit in stand-by mode. Insert the barrel connector from the power supply into the DC connector on the rear of the iM7BLK. After this connection is made, insert the power supply into a wall outlet. The "+" and "­" buttons marked with the word "volume" control the master volume. Install eight D batteries (or LR20) into the battery compartment on the bottom of the iM7BLK. Make sure the batteries are installed as illustrated in the battery compartment (batteries not included). With your iPod seated into the iM7BLK docking station, turn on your iPod. Turn on the iM7BLK by pushing the power button located on the top of the unit. Note: To avoid hearing a popping sound when you turn on your iM7BLK, always turn on your iPod (or alternate audio source) first. Turn off the iM7BLK by pushing the power button located on the top of the unit. When an iPod is docked into the iM7BLK and the iM7BLK is turned on, some iPod functions can be controlled using the inMotion iM7BLK system's remote control. [. . . ] Install eight fresh D batteries into the battery compartments located on the bottom of the iM7BLK. Make sure the batteries are installed per the illustration in the battery compartments. If using an alternate audio source, check volume level on the alternate audio source and set at mid-level. If using an alternate audio source, there's a problem with the audio source. [. . . ]