User manual ALPINE TMX-R705

[. . . ] R EN TMX-R705 Mobile Overhead Monitor · OWNER'S MANUAL Please read before using this equipment. · BEDIENUNGSANLEITUNG Lesen Sie diese Bedienungsanleitung bitte vor Gebrauch des Gerätes. · MODE D'EMPLOI Veuillez lire avant d'utiliser cet appareil. · MANUAL DE OPERACIÓN Léalo antes de utilizar este equipo. [. . . ] Each press changes the display modes as follows: MODE 1 (WIDE) MODE 2 (ZOOM) MODE 3 (CINEMA) MODE 4 (NORMAL) MODE 4 (NORMAL) A normal television broadcasting (4:3) image is displayed in the center (normal image). MODE 1 (WIDE) Stretches the normal image evenly in a horizontal direction so that it is displayed on the entire screen. FR ES MODE 2 (ZOOM) Stretches the normal image evenly in a horizontal direction so that it is displayed on the entire screen. The stretching ratio increases the closer to the left or right edge of the screen. DE IT MODE 3 (CINEMA) Stretches the normal image horizontally and vertically. or button within 10 seconds to set 1 2 3 Press the SETUP button. or button within 10 seconds to set SET UP AUX1 DIMMER AUTO DIMMER Lv. AT CLOSE OFF LOW HIGH PAGE 2 4 AUTO: Automatic closing of the display in depending upon whether the ignition switch is ON or OFF. If you press the POWER button or the OPEN/ CLOSE button while the monitor is being opened or closed, the monitor stops opening or closing, even if AUTO setting is on, and cannot be closed automatically. In this case, press the POWER button or the OPEN/ CLOSE button again to close the monitor. OFF: Manual closing of the display. SET UP AUX1 DIMMER AUTO DIMMER Lv. AT CLOSE OFF PAGE 2 9 9 9 Press the SETUP button to finish adjustments. 9 FR ES DE AUTO OFF 4 Press the SETUP button to finish adjustments. IT SE 9-EN Other Useful Features Dome Light Settings 1 Press the DOME LIGHT button to turn the Dome Light ON or OFF regardless of whether the vehicle's doors are open or closed. Door Closed: The dome light will remain lit until the vehicle's door is opened and closed. To switch OFF the dome light manually, press the DOME LIGHT button again. Door Open: The dome light will remain OFF until the vehicle's door is closed and re-opened. To switch ON the dome light manually, press the DOME LIGHT button again. NTSC/PAL Switching Function You can switch the NTSC/PAL setting in the AUX1 or AUX2 mode. 1 2 3 Press the SETUP button. Press the or the selection. button within 10 seconds to set · With the dome light ON and the vehicle's door OPEN, press and hold the DOME LIGHT button for at least 3 seconds. The dome light will be switched OFF permanently regardless of the opening and closing of the vehicle's doors. To cancel, with the vehicle's door open, press and hold the DOME LIGHT button for at least 3 seconds. NOTE If the Override button is connected, it will always work regardless of the Remote Dome Light Status. AUX 1 SIG. AUX 2 SIG. NTSC PAL 9 SET UP AUX1 NTSC PAL PAGE3 1 3 4 Press the SETUP button to finish adjustments. NOTE The TINT adjustment is not possible when the PAL is setted. TIPS NTSC and PAL can be directly switched when the DISP button is pressed for at least 2 seconds. 10-EN 9 Battery Replacement Applicable battery: Use two "AAA" sized dry batteries or equivalent. · Point the remote control transmitter toward the remote sensor on the TMX-R705 and use the remote control within 2 meters from the TMXR705. Replacing the Dome Light Bulb NOTE When replacing the dome light bulb, replace with one of the specified 12V, 5W capacity. Please note that no guarantee is carried out if this is the case. 1 2 3 4 5 1 Opening the battery cover. Slide out the battery cover while firmly pressing in the direction of arrow. Use 12V, 5W rated bulb (End Cap Base: T8 x 28) available at any autoparts store or consult your authorized Alpine Mobile Multimedia dealer for further information. Use a flat-bladed screwdriver to release the hooks and open the lense, being careful not to scratch the product. [. . . ] (Two persons may be needed. ) 1) Press the OPEN/CLOSE button of this unit, or press the POWER button, press and hold the OPEN/CLOSE button of the supplied remote control for at least 2 seconds. The monitor will automatically open and close with each press. NOTES · Do not forcibly open or close the monitor. · The monitor cannot be opened or closed unless the unit is turned upside down. DE IT 3-2 Use the supplied remote control to adjust the view angle of the monitor as required. (See Page 6 "Adjusting the Monitor Viewing Angle") NOTE Do not forcibly change the view angle of the monitor. [. . . ]