User manual ALPINE TME-M580

[. . . ] Any function that requires your prolonged attention should only be performed after coming to a complete stop. Always stop the vehicle in a safe location before performing these functions. Arrange wiring and cables in compliance with the manual to prevent obstructions when driving. Cables or wiring that obstruct or hang up on places such as the steering wheel, gear lever, brake pedals, etc. [. . . ] If the main power lamp illuminates in the STAND BY mode, the vehicle's battery may be discharged. Note: When the movie output type is not compatible, the movie does not output normally. Each press of the button will cycle through the modes as follows: NAVIGATION AUX Switching the display mode. Each press of the button will cycle through the modes as follows: WIDE CINEMA ZOOM NORMAL WIDE: Normal images are expanded uniformly in the horizontal direction and are displayed over the entire screen. CINEMA: Normal images are expanded in the horizontal and vertical directions. ZOOM: Normal images are expanded in the horizontal direction and are displayed over the entire screen. The expansion ratio increases towards the right and left edges of the screen. NORMAL: Normal image (4:3) Page 4 Operation Reset the Monitor Settings 1. : Standard - Navigation for all others (except Europe) : Europe - Navigation for Europe only If no key is pressed within 10 seconds, the On-Screen Display wil turn off. Each press of the button will cycle through the modes as follows: BRIGHT COLOR TINT MONITOR DIMMER MIRROR DIM. Note: It is not adjustable in NAVIGATION (RGB connection) and PAL mode. · DIMMER: AUTO: Display illumination will dim when while the car's parking lights are on. · MIRROR: Switch the picture to NORMAL/MIRROR (for rear view camera) image. After completing adjustments, press and hold the SEL button for at least 1 second. If no key is pressed within 10 seconds, the OSD will turn off and any changes made are automatically set. Notes: · After turning the system off, a slight ghost of the image will remain temporarily. · Under cold temperature conditions, the screen may lose contrast temporarily. · The LCD panel is manufactured using an extremely high precision manufacturing technology. This means that there is a possibility that 0. 01% of the pixels could be either always ON or OFF. Page 5 In Case of Difficulty If you encounter a problem, please review the items in the following check list. Otherwise, make sure the rest of your system is properly connected or consult your authorized Alpine dealer. Symptom No function or display. Navigation screen is not displayed or navigation system's remote controller keys do not work. Press the ON/OFF (POWER) button on the navigation system's remote controller to turn the navigation system's power on. [. . . ] 128 g (4. 5 oz. ) Note: Due to continuous product improvement, specifications and design are subject to change without notice. SERVICE CARE · For European Customers Should you have any questions about warranty, please consult your authorized Alpine Dealer. · For Customers in other Countries IMPORTANT NOTICE Customers who purchase the product with which this notice is packaged, and who make this purchase in countries other than the United States of America and Canada, please contact your dealer for information regarding warranty coverage. Page 8 TME-M580 + Video and Navigation Power Harness Color Code 1 Ground NOT USED Accessory NOT USED Foot Brake (+) Parking Brake (-) Dimmer (+) IR Remote Black OPEN Red OPEN Yellow/Black Yellow/Blue White/Blue White/Brown 3 pin EXT. PWR Cord This cord is only used when using this monitor as a navigation monitor only. 2 3 4 5 6 7 8 MIC/SW TD DISP. EX-1 EX-2 POWER GPS ANT. White Brown 5 10 1 6 VIDEO 13 Pin Nav Cable (included with Alpine Navigation systems) Ext Box Front side Ext Box Back side 8 Pin Power Harness 8 Pin to Monitor TO BRAIN TO NAV NOT USED 8 Pin Din to Monitor Brain 3 Pin EXT 13 Pin Nav (if running Cable to Alpine Navigation nav only) Page 9 TME-M580 + Navigation Only Power Harness Color Code 1 2 3 4 5 6 7 8 MIC/SW TD DISP. EX-1 EX-2 POWER GPS ANT. Ground NOT USED Accessory NOT USED Foot Brake (+) Parking Brake (-) Dimmer (+) IR Remote Black OPEN Red OPEN Yellow/Black Yellow/Blue White/Blue White/Brown 5 10 1 6 13 Pin Nav Cable (included with Alpine Navigation systems) Ext Box Front side Ext Box Back side 8 Pin Power Harness 8 Pin to Monitor NOT USED TO NAV TO BRAIN 8 Pin Din to Monitor Brain 3 Pin EXT 13 Pin Nav (if running Cable to Alpine Navigation nav only) NOTE: Please use the tape included to tie both cables together to ensure the cable will not come loose from the monitor. Page 10 TME-M580 + Video Only Power Harness Color Code 1 2 3 4 5 6 7 8 Ground NOT USED Accessory NOT USED Foot Brake (+) Parking Brake (-) Dimmer (+) IR Remote Black OPEN Red OPEN Yellow/Black Yellow/Blue White/Blue White/Brown 3 pin EXT. PWR Cord This cord is only used when using this monitor as a navigation monitor only. VIDEO White Brown EXT Box Front side EXT Box Back side 8 Pin Power Harness 8 Pin to Monitor TO BRAIN NOT USED NOT USED 8 Pin Din to Monitor Brain 3 Pin EXT 13 Pin Nav (if running Cable to Alpine Navigation nav only) Page 11 /////alpine® ALPINE ELECTRONICS, INC. Tokyo office: 1-1-8 Nishi Gotanda, Shinagawa-ku, Tokyo 141-8501, Japan Tel. : (03) 3494-1101 ALPINE ELECTRONICS OF AMERICA, INC. [. . . ]