User manual ALPINE TDA-7561R

[. . . ] OWNER'S MANUAL Please read this manual to maximize your enjoyment of the outstanding performance and feature capabilities of the equipment, then retain the manual for future reference. The exclamation point within an equilateral triangle and "WARNING" are intended to alert the user to the presence of important operating instructions. When problems occur such as a lack of sound or video, foreign objects inside the unit, smoke coming out, or noxious odors, stop use immediately and contact the dealer where you bought the equipment. Operating the equipment may distract the driver from looking ahead of the vehicle and cause accident. [. . . ] When the RDS station signal received has become weak: · AF seek mode, press and hold the AF button for at least 2 seconds to have the unit automatically seek a stronger station in the AF list. Make sure that the lamp on the F button is illuminated, and press the preset location button in which your desired RDS station is preset. If the preset station's signal is weak, the unit automatically searches and tunes to a stronger station in the AF (Alternative Frequencies) list. If the preset station and the stations in the AF list cannot be received: The unit searches again for a station in the PI (Programme Identification) list. If there are still no stations receivable in the area, the unit displays the frequency of the preset station and the preset indicator disappears. If the signal level of the Regional (Local) station being tuned becomes too weak to receive, press the same preset location button to tune in a Regional station in other district. Press and hold the INTLZ button for at least 3 seconds to activate the setting mode. In the REG OFF mode, the unit automatically keeps receiving the related local RDS station. When a traffic information station is tuned in, the TP indicator lights up. If traffic information is not being broadcast, the unit is set in the standby mode. When a traffic information broadcast begins, the unit automatically receives it and the display shows "TRF-INFO" for a few seconds, then returns to the previous display. When traffic information broadcast is over, the unit will automatically set in the standby mode. If the traffic information broadcast signal falls below a certain level, the unit remains in the receiving mode for 1 minute. If the signal remains below a certain level for over 1 minute, the "T. If you do not want to listen to the traffic information being received, lightly press the T. INFO mode will remain in the ON position to receive the next traffic information message. This feature is functional when your unit is set to a mode other than the LW and MW. "PRIO PTY" is displayed for 2 seconds and then the programme type for 5 seconds. " Note: If no button is pressed within 5 seconds after pressing the P. Press the DN g or f UP button within 5 seconds while "NEWS" is being displayed to choose a desired programme type. In the PTY31 ON mode, the unit will show "ALARM" in the display when the unit receives the PTY31 (Emergency Broadcast) signal. When the cassette is loaded, the player automatically starts tape playback and indicates "TAPE" in the display. [. . . ] The unit will automatically search for the disc and will play that disc. Press and hold the SOURCE button for at least 3 seconds to activate the title erasing mode. Press the DN g or f UP button repeatedly until the disc title you want to erase is displayed. Press and hold the SOURCE button for at least 3 seconds to erase the disc title displayed. [. . . ]