User manual ALPINE SBS-0715

[. . . ] Use for other than its designed application may result in fire, electric shock or other injury. The wiring and installation of this unit requires special technical skill and experience. To ensure safety, always contact the dealer where you purchased this product to have the work done. Use of other than designated parts may damage this unit internally or may not securely install the unit in place. [. . . ] Lowering the volume so that the amplifier is not operating at full power results in better sound, with clear highs and tighter lows. exposing speakers to excessive input resulting in crackling sound for prolonged periods of time will damage them. Listen to the sound to determine whether or not the input is excessive. , is adjusted to eliminate distortion it may not be possible to achieve sufficient acoustic pressure (volume). 3 kg Specifications and appearance of the product may change without prior notice. (For easy removal, use a bent paper clip (or similar item) to pull up on the corners. Choose a mounting position near the center of the dashboard that will not interfere with the driver. Mount the unit in a location that is as close to horizontal as possible. (Minor leveling adjustments at the mounting location can be made with the plate 3. ) · The adhesive on the plate 3 is very strong and may damage the mounting surface if peeled off. Make sure the location you have chosen is final before peeling off the adhesive backing and pressing the plate 3 into place. When mounting the speaker directly on the dashboard, the speaker cord can be wired from either the front or back of the speaker. Amplifier mounting Mount the amplifier under the passenger seat or in the trunk room, etc. Warning: Do not contact, damage or obstruct pipes, fluid lines or wiring when drilling holes. For vehicles equipped with a computer, note that disconnecting the battery's negative terminal may clear the memory. For some models (especially of non-Japanese makes), disconnecting the battery's negative terminal may cause problems in the electrical equipment. Connect with care, paying close attention to the labels on the cords and to the instructions. Mount the speaker on the specified location after wiping brightener, wet part, dust, oil, etc. [. . . ] 3 Peel off the back paper of the plate 3 and put the plate on the dashboard. 3 Next, gradually raise the amplifier's input sensitivity, and stop at a position at which the overall system is balanced. The sound may be distorted if the input sensitivity is raised too much. The sound may also be distorted if the digital audio processor's volume is raised too much. [. . . ]