User manual ALPINE RUE-4191

[. . . ] Remove the remote control from the holder and put it in the glove compartment. ⷠIf double-sided adhesive tape cannot install the holder securely, use screws. [. . . ] Any function that requires your prolonged attention should only be performed after coming to a complete stop. Always stop the vehicle in a safe location before performing these functions. Insert new ones matching the (+) and (­) polarities as shown in the diagram inside the remote control. After pressing the MODE button, press the following buttons while the status indicator is blinking: Numeric Keypad (0 to 9). @ [ \ ] Remote Control Transmitter -- Status indicator for EXT DVD mode -- DVD Changer mode: Disc Selection Audio SOURCE button (When connected with the Ai-NET Head Unit) L (STOP) button VOLUME UP/DOWN (When connected with the Ai-NET Head Unit) MUTE button (When connected with the Ai-NET Head Unit) MENU button Press and hold for 2 seconds to display the setup menu. (Subtitle) button Press and hold this for 2 seconds to turn the subtitles ON and OFF. Button (When connected with the Digital Audio Processor) Playback, Press and hold for 2 seconds to playback the slow motion. Power ON/OFF button Chapters and tracks skip Press and hold for 2 seconds to BW/FF. Failure to heed them can result in injury or material property damage. When inserting the batteries, be sure to observe proper polarity (+ and ­) as instructed. [. . . ] Clean with a soft, lint-free cloth or cotton swab slightly dampened with a mild solution of detergent and water. Do not operate this unit in a manner that could distract you from driving safely. [. . . ]