User manual ALPINE PDX-1.1000

[. . . ] ENGLISH R Introduction: Please read this OWNER'S MANUAL thoroughly to familiarize yourself with each control and function. We at ALPINE hope that your new PDX-1. 1000 will give you many years of listening enjoyment. In case of problems when installing your PDX-1. 1000, please contact your authorized ALPINE dealer. Failure to heed them can result in injury or property damages. PDX-1. 1000 MONO POWER AMPLIFIER · OWNER'S MANUAL Please read this manual to maximize your enjoyment of the outstanding performance and feature capabilities of the equipment, then retain the manual for future reference. [. . . ] CAUTION Caution on connection terminals/parts · Do not allow other objects (particularly electrically conductive) to get too close or in contact with any of the unit's terminals/parts (power supply, fuse, speaker output terminal, RCA connector, etc. ). Note: Stack installation should always be parallel to the vehicle floor ­ do not install at an incline, such as leaning against a vertical surface, as this will invalidate your warranty. Make sure there are no objects behind the surface that may become damaged during drilling. Position the PDX-1. 1000 over the screw holes, and secure with four self-tapping screws. NOTE: To securely connect the ground lead, use an already installed screw on the metal part of the vehicle (marked ). Be sure this is a good ground by checking continuity to the battery (­) terminal. Remove the four corner top caps on top using the hexagon wrench (large, supplied). Fasten the unit down with the four self-tapping screws (M4 x 40, supplied). Refer to fig. 2. Firstly, securely install one unit, as described in steps 1-3 of A above. Attach the four joint caps in the four corners of the first unit with 2 machine screws (M2. 6 x 14, supplied) per each cap. Stack the second unit on top of the installed unit, aligning the second unit's feet with the joint caps of the first unit. Remove the four corner top caps of the second unit using the hexagon wrench (large, supplied). Insert the four machine screws (M4 x 36, supplied) through the top of the second unit into the four joint caps of the lower unit to connect them together. Re-attach the four top caps to the second unit using the hexagon wrench (big, supplied). Firstly, securely install the first two units firmly as described in steps 1 to 5 of B above. Next, install the third unit as described for the second unit in B above. With this, stack installation of the 3 units is completed. 2 Fig. This fuse will protect your vehicle's electrical system in case of a short circuit. If you need to extend this lead, only use AWG4 - AWG6 (the wire gauge) for this connection. Cautions on Power Wire connections The power wire cannot be connected until its end has been stripped. · If you make this connection yourself, ensure the connection is correct by following the instructions below carefully. · Be sure to use the supplied hexagon screws for this connection. · To prevent disconnection of the leads or dropping of the unit, do not carry the unit by the wire. [. . . ] Then turn on the unit and verify that the indicator color has changed to blue. The indicator color changes to blue. Blue Red $ Switch Panel/ Panneau des commutateurs/ Panel de interruptores % Fig. 9 CONNECTION CHECH LIST (Fig. 10) Please check your head unit for the conditions listed below: (Fig. The head unit's power antenna lead is activated only when the radio is on (turns off in the tape or CD Mode). [. . . ]