User manual ALPINE KTC-221GY
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ALPINE KTC-221GY. We hope that this ALPINE KTC-221GY user guide will be useful to you.
 |
ALPINE KTC-221GY : Download the complete user guide (202 Ko) |
Manual abstract: user guide ALPINE KTC-221GY
Detailed instructions for use are in the User's Guide.
[. . . ] KTC-221GY KTC-221TN
50-0387A-002 50-0387A-014
INSTALLATION MANUAL
FORD EXPEDITION/ LINCOLN NAVIGATOR
Overhead Console for use with Mobile Overhead Monitor
These instructions are intended for use only by experienced professionals in the automotive customizing business. Special tools and equipment, as well as specialized handling and care of product during installation, may be required. Before beginning this installation, carefully read through the following instructions. [. . . ] jumper harness that will connect the vehicle's dome light wires to the lights in LCD monitor housing. Refer to wiring/connections section of the TMX-680A owner's manual for details. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. The suggested routing of the video system cable is as follows: Above the headliner from video system to C-pillar. Connect per instructions included remaining
4
with the video system. If video system if to be used as a television, install an appropriate antenna per instructions included with the antenna.
12. Install block-off cover (item 9 pg 2) and secure using (2) two # 8 x 9/16" screws (item 2 pg 2) at rear area. Detach A/C wire harness from brace to allow connectors to reach the new A/C control location. Install mounting bracket (item 8 pg 2 ) by inserting tabs into slots in O. E. screws removed in step 4 into their original location and (1) one #8x 1" screw (itemPHOTO)5in rear location. Install convoluted tube (item 5 pg 2) around wire harness to prevent chaffing against bracket. Remove A/C control from rear bezel assembly previously removed in step 1. Make sure control is centered and secure using (5) five # 6 X 3/8" screws (item 1 pg 2). INSTALLATION OF CONSOLE
.
Caution: Use extra support for the console until secured to the vehicle. [. . . ] For further assistance, refer to the TMX-R680A owner's manual for the technical support phone number listed for your area.
23. Note : Make sure wires do not get pinched Between housingPHOTO 9 and console. Position them against the console door and press firmly on remote while holding the door. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE ALPINE KTC-221GY
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ALPINE KTC-221GY will begin.