User manual ALPINE KTC-211SH

[. . . ] KTC-211PW KTC-211SH 50-0385A-018 50-0385A-026 INSTALLATION MANUAL 2000 SUBURBAN / YUKON XL Overhead Console for use with Mobile Overhead Monitor These instructions are intended for use only by experienced professionals in the automotive customizing business. Special tools and equipment, as well as specialized handling and care of product during installation, may be required. [. . . ] Use rubbing alcohol to clean sheet metal in rear area of headliner cut out. Remove protective backing from adhesive strips on rear mounting bracket ( item 7 pg 2) and position tab 18 1/4" from rear edge ofPHOTO 5 front mounting bracket. Make sure bracket is centered left to right and firmly press against roof. jumper harness that will connect the vehicle's dome light wires to the lights in LCD monitor housing. Refer to wiring/connections section of the TMX-680A owner's manual for details. Install and route all video and audio cables, and any PHOTO 6 other added component requirements to their respective places in the vehicle. The suggested routing of the video system cable is as follows: Above the headliner from video system to B-pillar. 5 Down the B-pillar to the floor. Remove protective backing from adhesive strips on PHOTO 7 mounting brackets (item 9 pg 2 ) and press firmly against control head as shown. INSTALLATION OF CONSOLE . Caution: Use extra support for the console until secured to the vehicle. Failure to do so may cause damage to console or installed components. PHOTO 8 12. Install dome light switch (item 10 pg 2) into opening on front of console. Raise console into approximate position and connect A/C control wires. [. . . ] Note : Make sure wires do not get pinched between housing and console. Position them against the console door and press firmly on remote while holding the door. [. . . ]