User manual ALPINE KCE-104V

[. . . ] dO NOT USE BOLTS OR NUTS IN THE BRAKE OR STEERING SYSTEMS TO MAKE GROUND CONNECTIONS. Bolts or nuts used for the brake or steering systems (or any other safety-related system), or tanks should NEVER be used for installations or ground connections. Using such parts could disable control of the vehicle and cause fire etc. [. . . ] The wiring and installation of this unit requires special technical skill and experience. To ensure safety, always contact the dealer where you purchased this product to have the work done. aRRANGE THE WIRING SO IT IS NOT CRIMPED OR PINCHED BY A SHARP METAL EDGE. Route the cables and wiring away from moving parts (like the seat rails) or sharp or pointed edges. If wiring passes through a hole in metal, use a rubber grommet to prevent the wire’s insulation from being cut by the metal edge of the hole. Operation For proper operation, connect the REAR SEL1 or REAR SEL2 lead to chassis ground through a switch, etc. Also, operations can be performed from the CVA-1004/CVA-1004R when connected. For details, refer to the Owner's Manual of the CVA-1004/ CVA-1004R. Switching the output source The visual output from AUX OUT1/2 for each monitor can be switched. AUX1 → AUX2 → AUX3(CAMERA) → OFF∗ → AUX1 ∗Sólo al conectarlo al CVA-1004/CVA-1004R AUX1 → AUX2 → AUX3(CAMERA) → OFF∗ → AUX1 • If you select an unconnected source, noise may occur. Connect the REAR SEL1 or 2 lead to chassis ground for at least 2 seconds. Connect the REAR SEL1 or 2 lead momentarily to the ground to select SETUP item. Connect the REAR SEL1 or 2 lead to chassis ground for at least 2 seconds to change each setting. MODE3: Visual Effect is applied continuously on the two monitors which are output from AUX OUT 1/2 terminals. [. . . ] 5 Battery Lead (Yellow)/Fil de batterie (jaune)/Cable de la batería (amarillo) Connect this lead to the positive (+) post of the vehicle's battery. Ignorera inte det som sägs här, eftersom det kan leda till allvarliga olyckor, till och med med dödlig utgång. Användandet av andra delar än som är avsedda för denna apparat kan leda till att apparaten skadas invändigt eller till ostadig montering på grund av lossnande delar. [. . . ]