User manual ALPINE ILX-700

[. . . ] Use of other than designated parts may damage this unit internally, or may not securely install the unit in place. This may cause parts to become loose resulting in hazards or product failure. Route the cables and wiring away from moving parts (like the seat rails) or sharp or pointed edges. If wiring passes through a hole in metal, use a rubber grommet to prevent the wire’s insulation from being cut by the metal edge of the hole. [. . . ] dO NOT PLACE HANDS , FINGERS OR FOREIGN OBJECTS IN INSERTION SLOTS OR GAPS. Avoid installing the unit in locations with high incidence of moisture or dust. Moisture or dust that penetrates into this unit may result in product failure. Failure to make the proper connections may result in fire or product damage. Doing so will exceed the current carrying capacity of the wire and result in fire or electric shock. When drilling holes in the chassis for installation, take precautions so as not to contact, damage or obstruct pipes, fuel lines, tanks or electrical wiring. dO NOT USE BOLTS OR NUTS IN THE BRAKE OR STEERING SYSTEMS TO MAKE GROUND CONNECTIONS. Bolts or nuts used for the brake or steering systems (or any other safety-related system), or tanks should NEVER be used for installations or ground connections. Using such parts could disable control of the vehicle and cause fire, etc. 2-EN ALPINE iLX-700 QRG 68-24567Z83-A (EN) Owner’s manual Touch operation , Location of Controls , Turning Power On or Off Getting Started DER EL OR etc. , and Touch operation You can operate the system by using the touch panel on the screen. This may cause a distraction, taking your attention away from safely driving your vehicle. Carefully consider direction and distance while mounting the microphone. Confirm that the driver’s voice can be easily picked up at the selected location. € Do not block the unit’s heat sink, which would prevent air circulation. If blocked, heat will accumulate inside the unit and may cause a fire. Rear of the Unit Cable clamp (Sold separately) Microphone nal) y be Heat sink Uninstalling the original car stereo 1 2 Uninstall the car stereo with its mounting bracket. Remove the cables and the mounting bracket attached to the car stereo. €) 7-EN ALPINE iLX-700 QRG 68-24567Z83-A (EN) Installing the Unit 3 4 1 2 Remove the Face Plate from the unit. Mount the original mounting bracket to the unit using the supplied screws. Connect all other leads of the unit according to details described in the “Connections” section (page 9). Do not damage them by tucking them into movable parts, such as a seat rail, or by locating them against sharp or pointed edges. [. . . ] Do not damage them by tucking them into movable parts, such as a seat rail, or by locating them against sharp or pointed edges. Connection Diagram of SPST Switch (sold separately) (If the ACC power supply is not available) ACC (Red) iLX-700 BATTERY (Yellow) FUSE (20A) (Optional) SPST SW (Optional) FUSE (5A) (Optional) Battery • If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately). € The diagram and the fuse amperage shown above are in the case when iLX-700 is used individually. € If the switched power (ignition) lead of the iLX-700 is connected directly to the positive (+) post of the vehicle’s battery, the iLX-700 draws some current (several hundred milliamperes) even when its switch is placed in the OFF position, and the battery may be discharged. [. . . ]