User manual ALPINE HCE-C155

[. . . ] Incorrect connections may cause the unit to malfunction or cause damage to the vehicle’s electrical system. Return it to your authorized Alpine dealer or the nearest Alpine Service Center for repairing. Doing so could cause the strength of the camera mounting to weaken, which could cause it to fall of and cause accidents, injury, or damage to the car body. dO NOT ATTACH THE CAMERA MOUNTING TO ANY SURFACE WHERE THE ENTIRE ADHESIVE SURFACE CANNOT BE APPLIED. [. . . ] When washing the car, do not using an automatic car washer, or highpressure washer. Doing so could cause the camera to come off, damage to the device cord, or may allow water to enter the camera or the inside of the car. In some cases, to attach the device, a hole must be drilled in the car body, requiring use of touch-up paint (retail product) for rust-prevention, and should be prepared beforehand. Be sure to disconnect the cable from the (–) battery post before installing your HCE-C155. This will reduce any chance of damage to the unit in case of a short-circuit. Incorrect connections may cause the unit to malfunction or damage to the vehicle’s electrical system. When making connections to the vehicle’s electrical system, be aware of the factory installed components (e. When connecting the HCE-C155 to the fuse box, make sure the fuse for the intended circuit of the HCEC155 has the appropriate amperage. About Rear Camera The rear camera of this camera system is a dedicated product. About Power Connection Connect a reverse input cable (orange/white) to the power cable of the rear lamp. Connect this to a power cable of the rear lamp, but not to the positive of the rear lamp signal cable. It is recommended to use mobile phones or wireless devices away from the camera. About Camera Installation Location Before installing, make sure there is a enough space to be able to install the camera. If possible, install the camera in the center of the bumper or other fitting. If the camera is installed at a distance left or right of center, the image may differ from the real view. Confirming the Display Function To connect the unit, confirm that the monitor will require a compatible RCA pin jack. Användandet av andra delar än de som är avsedda för denna apparat kan leda till att apparaten skadas invändigt eller till ostadig montering på grund av lossnande delar. Par conséquent, il existe une différence entre la distance perçue à l’écran et la distance réelle. När du gör anslutningarna till fordonets elsystem måste du ta hänsyn till de komponenter som redan är installerade (t. När du ansluter HCE-C155 till säkringsplinten måste du se till att säkringen för den krets du tänker använda har rätt amperetal för HCE-C155. Failure to heed them can result in injury or material property damage. Anslut denna till en av baklampans strömkablar, men inte till baklampans positiva (+) signalkabel. [. . . ] Connect to A Video Output Connector Connect the RCA extension cable (included), and then to the camera video input connector of the connected device. English Caution When adjusting the camera angle, do so after turning off the engine and applying the hand brake to avoid an accident. 5A When reversing the vehicle, the lead is used to supply power to the unit. Connect the lead to the positive side of the rear lamp feed of the vehicle, or the ACC position. [. . . ]