User manual ALPINE HCE-C105

[. . . ] Use of other than designated parts may damage this unit internally or may not securely install the unit in place. This may cause parts to become loose resulting in hazards or product failure. Return it to your authorized Alpine dealer or the nearest Alpine Service Centre for repairing. [. . . ] Be sure to disconnect the cable from the (–) battery post before installing your HCE-C105. This will reduce any chance of damage to the unit in case of a short-circuit. Incorrect connections may cause the unit to malfunction or damage to the vehicle's electrical system. When making connections to the vehicle's electrical system, be aware of the factory installed components (e. When connecting the HCE-C105 to the fuse box, make sure the fuse for the intended circuit of the HCE-C105 has the appropriate amperage. In some cases, to attach the camera, a hole must be drilled in the car body, requiring use of touch-up paint (retail product) for rust-prevention, and should be prepared beforehand. Use for other than its designed application may result in fire, electric shock or other injury. Ignorera inte det som sägs här, eftersom det kan leda till allvarliga olyckor, till och med med dödlig utgång. Användandet av andra delar än som är avsedda för denna apparat kan leda till att apparaten skadas invändigt eller till ostadig montering på grund av lossnande delar. När du gör anslutningarna till fordonets elsystem måste du ta hänsyn till de komponenter som redan är installerade (t. När du ansluter HCE-C105 till säkringsplinten måste du se till att säkringen för den krets du tänker använda har rätt amperetal för HCE-C105. 2/Bild 2/圖2 English 1 Attach the camera to the camera mounting 3. Pull the camera cable through to the camera mounting 3, and secure with the hex screws 4 (see Fig. Determine the attachment angle, and carefully tighten the angle adjustment screw. 4 Pull the camera cable inside the car through the hole made in step 3. 5 Peel off the adhesive seal from the camera mounting and attach the camera mounting on the chassis of the vehicle. € • • • Attach the camera in a position where it does not touch the number plate. Use retail touch-up paint to paint the surface and surrounding area when a hole has been made in a metal surface. [. . . ] € • • Ensure the cable does not get caught in the trunk, rear door(s) or any hinges. After completing wiring, open and close the trunk and the rear doors several times to confirm the cable is not getting caught or rubbing anywhere. Anslut denna ledning till den positiva sidan för strömmatningen till backlampan, eller ACC-läget. [. . . ]