User manual ALPINE CHM-S611

[. . . ] IMPORTANT Please record the serial number of your unit in the space provided here and keep it as a permanent record. Read this manual carefully before starting operation and use this system safely. We cannot be responsible for problems resulting from failure to observe the instructions in this manual. This manual uses various pictorial displays to show how to use this product safely and to avoid harm to yourself and others and damage to your property. [. . . ] If the spring configuration is incorrect or the spring positions on the left and right sides are not the same, the shock absorbing mechanism will not function properly. NOTE: After setting the spring position, put on the label covers on the cutouts at both sides. Connections q The CHM-S611 CD Shuttle is not equipped with built-in control unit and power amplifier. Consult your authorized Alpine dealer for connections of your control unit and power amplifier. nOTES: · When this unit is connected to a 5953 (CD Changer Controller), its P. The CHM-S611 is designed for 12-volt DC negative ground operation so make sure that your vehicle has this system before making electrical connections. 1 8-pin DIN Connector Connect this to your control unit or changer control input of your Alpine Shuttle-ready head unit. to prevent external noise from entering the audio system · Locate the unit and route the leads at least 10 cm away from the car harness. Keep the battery power leads as far away from other leads as possible. Connect the ground lead securely to a bare metal spot (remove the coating if necessary) of the car chassis. If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various Alpine noise suppressors, contact them for further information. Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information. Use of other than designated parts may damage this unit internally or may not securely install the unit in place as parts that come loose may create hazards. A high incidence of moisture or dust that penetrates into this unit may cause smoke or fire. Proper care of your disc/Entretien des disques compacts/Cuidado adecuado de su disco Use the hexagon washer-head bolts (M4 x 8) to fasten the two "L" type mounting brackets (supplied) to the sides of the CD Shuttle. For routine cleaning, wipe the playing surface with a clean, soft cloth from the center of the disc to the outer edge. If the surface is heavily soiled, dampen a clean, soft cloth in a solution of mild neutral detergent before cleaning the disc. 3) Various disc accessories for protecting the surface of the disc and improving sound quality are available on the market. However, many of them will increase the thickness and/or diameter of the disc. Using such accessories may place the disc beyond the specified size limitations and cause the changer to malfunction. Because of the high precision electronics of the CHM-S611 and the highly stable mechanism, these accessories are not necessary and therefore not recommended for use with discs placed in the CHM-S611. [. . . ] Insert each CD tray, with the disc loaded, all the way into the CD magazine (Fig. Insert the CD magazine 1 all the way into the Shuttle until it locks with the narrow side facing the unit as shown in Fig. After inserting the CD magazine 1, close the CD magazine compartment door by sliding it to the left. 7) Caution: Door must be completely closed and remained closed at all times to prevent dust, water and smoke contaminants from diminishing the overall performance of the CD Shuttle. [. . . ]