User manual ALPINE CHA-S624

[. . . ] CAUTION: Do not install the Shuttle near the vehicle's fuel tank. Never install the Shuttle on the rear deck or front dashboard of the car. The temperatures caused by direct sunlight at these locations can reach extremes that could cause permanent damage to the Shuttle. [. . . ] 1: Analog output, 2: Digital output With the system not using the digital output, be sure to set the switch to "1" position. Make sure that the "L" type connector of the Ai-NET cable is attached to the Controller and the straight connector is attached to the CHA-S624. 3 Digital Output Terminal This terminal may be used to connect the CHA-S624 to other Alpine digital products, incorporating optical digital inputs. These products include a fiber optic cable that will plug directly into the Digital Output Terminal of the CHA-S624. Use the corresponding Input/Output ID labels to maintain proper connections when extension cables are used. 3) · In combination with products using optical digital system (Fig. With Ai-NET System 7 Optical Digital Unit with Ai-NET System 8 Digital/Analog Switch Position: 1 9 Digital/Analog Switch Position: 2 !Fiber Optic Cable (Included in the another factory unit or sold separately 4915/4916) q Cautions for Connections · Head unit with Ai-NET capability and Ai-NET Cable (Fig. Use of other than designated parts may damage this unit internally or may not securely install the unit in place as parts that come loose may create hazards. A high incidence of moisture or dust that penetrates into this unit may cause smoke or fire. Proper care of your disc/Entretien des disques compacts/Cuidado adecuado de su disco Use the hexagon washerhead bolts (M4 x 8) to fasten the two "L" type mounting brackets (supplied) to the sides of the CD Shuttle. Do not allow any cables in the vehicle to come into contact with the unit. It is possible, the constant vibration and movement in the vehicle can cause the cable's insulation to wear through. For routine cleaning, wipe the playing surface with a clean, soft cloth from the center of the disc to the outer edge. If the surface is heavily soiled, dampen a clean, soft cloth in a solution of mild neutral detergent before cleaning the disc. 3) Various disc accessories for protecting the surface of the disc and improving sound quality are available on the market. However, many of them will increase the thickness and/or diameter of the disc. Using such accessories may place the disc beyond the specified size limitations and cause the changer to malfunction. [. . . ] Insert the CD magazine 1 all the way into the Shuttle until it locks with the narrow side facing the unit as shown in Fig. After inserting the CD magazine 1, close the CD magazine compartment door by sliding it to the left. 7) Caution: Door must be completely closed and remained closed at all times to prevent dust, water and smoke contaminants from diminishing the overall performance of the CD Shuttle. [. . . ]