User manual ALPINE CHA-S614

[. . . ] Installation of Shuttle With the CHA-S614, CDs are automatically removed from and reinserted into the CD magazine, DO NOT mount the unit upside down, as this could cause the mechanism to become misaligned. CAUTION: Do not install the Shuttle near the vehicle's fuel tank. Never install the Shuttle on the rear deck or front dashboard of the car. The temperatures caused by direct sunlight at these locations can reach extremes that could cause permanent damage to the Shuttle. [. . . ] Mounting in the Trunk Make sure the mounting angle of the Shuttle installation will fall within the five preset positions (22. If you wish to install it at any other angle, change the spring configuration as shown. Remove the covers provided at both left and right sides of the unit by pressing claws of the covers in the direction shown by the arrow. Use the figure to determine which spring position would be best suited for your chosen mounting location. If the spring configuration is incorrect or the spring positions on the left and right sides are not the same, the shock absorbing mechanism will not function properly. Mount the covers at the left and right sides as they were attached originally. Change the switch position using a small screwdriver or other pointed object. CAUTION: When switching the Bus Selector Switch, make sure there are no cables attached to the CHA-S614. Make sure that the "L" type connector of the Ai-NET cable is attached to the Controller and the straight connector is attached to the CHA-S614. Use the corresponding Input/Output ID labels to maintain proper connections when extension cables are used. Use of other than designated parts may damage this unit internally or may not securely install the unit in place as parts that come loose may create hazards. A high incidence of moisture or dust that penetrates into this unit may cause smoke or fire. Proper care of your disc/Entretien des disques compacts/Cuidado adecuado de su disco Use the hexagon washerhead bolts (M4 x 8) to fasten the two "L" type mounting brackets (supplied) to the sides of the CD Shuttle. For routine cleaning, wipe the playing surface with a clean, soft cloth from the center of the disc to the outer edge. If the surface is heavily soiled, dampen a clean, soft cloth in a solution of mild neutral detergent before cleaning the disc. 3) Various disc accessories for protecting the surface of the disc and improving sound quality are available on the market. However, many of them will increase the thickness and/or diameter of the disc. Using such accessories may place the disc beyond the specified size limitations and cause the changer to malfunction. Because of the high precision electronics of the CHA-S614 and the highly stable mechanism, these accessories are not necessary and therefore not recommended for use with discs placed in the CHA-S614. 4) When a newly purchased disc is inserted into the changer magazine, the disc may fail to play after initial loading. This is caused by small bumps around the center hole and outside of the disc, which prevent stable loading into the correct position. To remove the bumps, rub the inside edge of the hole and outside edge of the disc with a ball-point pen or other such instrument, then insert the disc again. [. . . ] Insert each CD tray, with the disc loaded, all the way into the CD magazine (Fig. Insert the CD magazine 1 all the way into the Shuttle until it locks with the narrow side facing the unit as shown in Fig. After inserting the CD magazine 1, close the CD magazine compartment door by sliding it to the left. 7) Caution: Door must be completely closed and remained closed at all times to prevent dust, water and smoke contaminants from diminishing the overall performance of the CD Shuttle. [. . . ]