User manual ALPINE CHA-1214

[. . . ] Doing so may exceed the current carrying capacity of the wire and result in fire or electric shock. dO NOT INSTALL IN LOCATIONS WHICH MIGHT HINDER VEHICLE OPERATION OR CREATE HAZARDS FOR VEHICLE OCCUPANTS. dO NOT CONTACT , DAMAGE OR OBSTRUCT PIPES , FLUID LINES OR WIRING WHEN DRILLING HOLES. Failure to take such precautions may result in fire or cause an accident or injuries. [. . . ] Do not insert hands, fingers or foreign objects in the disc or cassette insertion slots, or in gaps during monitor startup/storage. Before making electrical connections, make sure that your car uses this type of system. Use of other than designated parts may damage this unit internally or may not securely install the unit in place as parts that come loose may create hazards. A high incidence of moisture or dust that penetrates into this unit may cause smoke or fire. When installation and connections are completed, · Are proper with klaxon, etc. 1 Ai-NET Input connector 2 Ai-NET Cable 3 Head unit equipped with Ai-NET connector 4 Connect as shown 5 Input/Output Labels 6 Match the arrow marks first, then connect. Proper care of your disc/Entretien des disques compacts/Cuidado adecuado de su disco Choose the proper mounting holes on the brackets to the mounting angle. Use the hexagon washer-head bolts (M4 x 8) to fasten the two "L" type mounting brackets (supplied) to the sides of the CD Shuttle. Note: If you plan to mount the changer at an angle, make sure that the magazine will not fall out when ejected. Have your hand ready to stop the magazine if it falls, then, press the EJECT button. If the magazine falls out of the changer when it is ejected, adjust mounting angle upwards. For routine cleaning, wipe the playing surface with a clean, soft cloth from the center of the disc to the outer edge. If the surface is heavily soiled, dampen a clean, soft cloth in a solution of mild neutral detergent before cleaning the disc. 3) Various disc accessories for protecting the surface of the disc and improving sound quality are available on the market. However, many of them will increase the thickness and/or diameter of the disc. Using such accessories may place the disc beyond the specified size limitations and cause the changer to malfunction. Because of the high precision electronics of the CHA-1214 and the highly stable mechanism, these accessories are not necessary and therefore not recommended for use with discs placed in the CHA-1214. Attach the "L" type brackets to both sides of the Shuttle with hexagon washer-head bolts (M4x8) . 6mm diameter tip and firmly mount brackets with hexagon flange-head bolts (M6x 50) and hexagon flange-head nuts (M6). 4) When a newly purchased disc is inserted into the changer magazine, the disc may fail to play after initial loading. This is caused by small bumps around the center hole and outside of the disc, which prevent stable loading into the correct position. To remove the bumps, rub the inside edge of the hole and outside edge of the disc with a ball-point pen or other such instrument, then insert the disc again. [. . . ] When removing the CD tray from the CD magazine, hold the tray securely so as not to drop the disc. Insert each CD tray, with the disc loaded, all the way into the CD magazine (Fig. Insert the CD magazine 1 all the way into the Shuttle until it locks with the narrow side facing the unit as shown in Fig. 7) Caution: Door must be completely closed and remained closed at all times to prevent dust, water and smoke contaminants from diminishing the overall performance of the CD Shuttle. [. . . ]