User manual ALPINE CHA-1204

[. . . ] CAUTION: Do not install the Shuttle near the vehicle's fuel tank. Never install the Shuttle on the rear deck or front dashboard of the car. The temperatures caused by direct sunlight at these locations can reach extremes that could cause permanent damage to the Shuttle. IMPORTANT Please record the serial number of your unit in the space provided here and keep it as a permanent record. [. . . ] 6mm diameter tip and firmly mount brackets with hexagon flange-head bolts (M6x 50) and hexagon flange-head nuts (M6). HAVE THE WIRING AND INSTALLATION DONE BY EXPERTS The wiring and installation of this unit requires special technical skill and experience. To ensure safety, always contact the dealer where you purchased this unit to have the work done. USE SPECIFIED ACCESSORY PARTS AND INSTALL THEM SECURELY Be sure to use only the specified accessory parts. Use of other than designated parts may damage this unit internally or may not securely install the unit in place as parts that come loose can create hazards. DO NOT INSTALL IN LOCATION WITH HIGH MOISTURE OR DUST Avoid installing the unit in locations with high incidence of moisture or dust. Moisture or dust that penetrates into this unit may cause smoke or fire. MAKE THE CORRECT CONNECTIONS Failure to make the correct connections can cause fire or accident to occur. ARRANGE THE WIRING SO IT IS NOT CRIMPED OR PINCHED Route the cables and wiring so as not be crimped by moving parts like seat rail or make contact with sharp or pointed spots which might damage the wiring. First, insert the Hexagon bolts (M6 x 25) up through the holes in the bottom of the floor base plates. The bolt heads should be recessed into the hole under the base plate so the base lays flat on the floor. Then, mount the floor base plates to the floor of the car with the Hexagon flange-head screws (M5 x 15). Cut mat in "+" shape with a knife to allow the threaded shaft of the floor base plates to come through. Les têtes des boulons doivent être encastrées dans le creux situé sous la plaque de fixation du support afin que le support repose à plat sur le plancher. Before making electrical connections, make sure that your car uses this type of system. When installation and connections are completed, check the followings: a) Connections are proper. Head unit equipped with Ai-NET connector Appareil principal équipé de connecteur Ai-NET Unidad de cabeza equipada con conector Ai-NET Match the arrow marks first, then connect. Preparation for playback Before operating the unit, follow the procedure below for loading the CD magazine. To remove the CD tray 3 from the CD magazine, pull the lever 2 with your finger (Fig. 2) NOTE: Hold the disc so you will not leave fingerprints on the disc surface (refer to "PROPER CARE OF YOUR DISC" section). When removing the CD tray from the CD magazine, hold the tray securely so as not to drop the disc. Insert each CD tray, with the disc loaded, all the way into the CD magazine (Fig. [. . . ] 2-3/8" x 9-13/16" x 6" (98 x 262 x 178 mm) NOTE: Due to product improvement, specifications and design are subject to change without notice. The Disc indicator in the head unit's display will change from "D" to "d. " Note: Model TDA-7537 (USA/Canada model), TDA-7638R/ 7537R (Europe models), TDA-7638E/7537E (other models) cannot access discs 7 to 12 from its front panel. Press one of the preset buttons 1 to 6 on the head unit while "d" is displayed. [. . . ]