User manual ALPINE CDM-7838R

[. . . ] OWNER'S MANUAL Please read this manual to maximize your enjoyment of the outstanding performance and feature capabilities of the equipment, then retain the manual for future reference. The exclamation point within an equilateral triangle and "WARNING" are intended to alert the user to the presence of important operating instructions. When problems occur such as a lack of sound or video, foreign objects inside the unit, smoke coming out, or noxious odors, stop use immediately and contact the dealer where you bought the equipment. Operating the equipment may distract the driver from looking ahead of the vehicle and cause accident. [. . . ] A total of 24 stations can be stored in the preset memory (6 stations for each band; FM1, FM2, MW and LW). Note: If you store a station in a preset memory which already has a station, the current station will be cleared and replaced with the new station. Each press changes the band: FM1 FM2 MW LW The tuner will automatically seek and store 6 strong stations in the selected band in order of signal strength. The frequency on the display continues to change while the automatic memory is in progress. When the automatic memory has been completed, the tuner goes to the station stored in the preset location No. Note: If no stations are stored, the tuner will return to the original station you were listening to before the auto memory procedure began. Each press changes the band: FM1 FM2 MW LW Make sure that the lamp on the F button is illuminated, then press the station preset button that has your desired radio station in memory. The display shows the band, preset number with a triangle and frequency of the station selected. The RDS allows you to receive a variety of information such as traffic information, station names, and to automatically re-tune to a stronger transmitter that is broadcasting the same programme. Note: When the BAND button is pressed and held for more than 2 seconds while a station name is displayed, the display shows the station frequency for 5 seconds. When the RDS station signal received has become weak: AF seek mode, press and hold the AF touche AF pendant au moins 2 secondes mantenga presionado el botón AF durante button for at least 2 seconds to have the pour que l'appareil recherche 2 segundos por lo menos para hacer que la unit automatically seek a stronger station automatiquement une station plus unidad busque automáticamente una in the AF (Alternative frequencies) list. Puissante dans la liste AF (fréquences emisora de señal más intensa de la lista de If there is no AF station, the display shows AF (frecuencias alternativas). Make sure that the lamp on the F button is illuminating, then press the preset location button in which your desired RDS station is preset. If the preset station's signal is weak, the unit automatically searches and tunes to a stronger station in the AF (Alternative Frequencies) list. If the preset station and the stations in the AF list cannot be received: The unit searches again for a station in the PI (Programme Identification) list. If there are still no stations receivable in the area, the unit displays the frequency of the preset station and the preset indicator disappears. If the signal level of the Regional (Local) station being tuned becomes too weak to receive, press the same preset location button to tune in a Regional station in other district. Press and hold the INTLZ button for at least 3 seconds to activate the setting mode. In the REG OFF mode, the unit automatically keeps receiving the related local RDS station. When a traffic information station is tuned in, the TP indicator lights up. If traffic information is not being broadcast, the unit is set in the standby mode. When a traffic information broadcast begins, the unit automatically receives it and the display shows "TRFINFO" for a few seconds and returns to the PS display. [. . . ] Fermeture du couvercle Closing the cover Push the cover as illustrated until a click is Poussez le couvercle comme illustré jusqu'au déclic. Fingerprints, dust, or soil on the surface of the disc could cause the CD player to skip. For routine cleaning, wipe the playing surface with a clean, soft cloth from the centre of the disc to the outer edge. If the surface is heavily soiled, dampen a clean, soft cloth in a solution of mild neutral detergent before cleaning the disc. [. . . ]