User manual ALPINE CDM-7837R

[. . . ] OWNER'S MANUAL Please read this manual to maximize your enjoyment of the outstanding performance and feature capabilities of the equipment, then retain the manual for future reference. The exclamation point within an equilateral triangle and "WARNING" are intended to alert the user to the presence of important operating instructions. When problems occur such as a lack of sound or video, foreign objects inside the unit, smoke coming out, or noxious odors, stop use immediately and contact the dealer where you bought the equipment. Operating the equipment may distract the driver from looking ahead of the vehicle and cause accident. [. . . ] Make sure that the lamp on the F button is illuminated, then press and hold any one of the preset buttons (1 through 6) for at least 2 seconds until the station frequency on the display blinks. Press the preset button into which you wish to store the station while the frequency display is blinking (within 5 seconds). Repeat the procedure to store up to 5 other stations onto the same band. To use this procedure for other bands, simply select the band desired and repeat the procedure. A total of 24 stations can be stored in the preset memory (6 stations for each band; FM1, FM2, MW and LW). Note: If you store a station in a preset memory which already has a station, the current station will be cleared and replaced with the new station. Each press changes the band: FM1 FM2 MW LW The tuner will automatically seek and store 6 strong stations in the selected band in order of signal strength. The frequency on the display continues to change while the automatic memory is in progress. When the automatic memory has been completed, the tuner goes to the station stored in the preset location No. Note: If no stations are stored, the tuner will return to the original station you were listening to before the auto memory procedure began. Each press changes the band: FM1 FM2 MW LW Make sure that the lamp on the F button is illuminated, then press the station preset button that has your desired radio station in memory. The display shows the band, preset number with a triangle and frequency of the station selected. The RDS allows you to receive a variety of information such as traffic information, station names, and to automatically re-tune to a stronger transmitter that is broadcasting the same programme. Note: When the BAND button is pressed and held for more than 2 seconds while a station name is displayed, the display shows the station frequency for 5 seconds. When the RDS station signal received has become weak: · AF seek mode, press and hold the AF button for at least 2 seconds to have the unit automatically seek a stronger station in the AF (Alternative frequencies) list. Make sure that the lamp on the F button is illuminating, then press the preset location button in which your desired RDS station is preset. If the preset station's signal is weak, the unit automatically searches and tunes to a stronger station in the AF (Alternative Frequencies) list. If the preset station and the stations in the AF list cannot be received: The unit searches again for a station in the PI (Programme Identification) list. If there are still no stations receivable in the area, the unit displays the frequency of the preset station and the preset indicator disappears. If the signal level of the Regional (Local) station being tuned becomes too weak to receive, press the same preset location button to tune in a Regional station in other district. Press and hold the INTLZ button for at least 3 seconds to activate the setting mode. In the REG OFF mode, the unit automatically keeps receiving the related local RDS station. [. . . ] Applicable battery: Use two "AAA" sized dry batteries or equivalent. Opening the battery cover Slide out the battery cover while firmly pressing outward. Closing the cover Push the cover as illustrated until a click is heard. Fingerprints, dust, or soil on the surface of the disc could cause the CD player to skip. [. . . ]