User manual ALPATEC UNICO EASY

[. . . ] GENERAL INFORMATION We wish to thank you, first of all, for purchasing an air-conditioner produced by our company. We are sure you will be happy with it because it represents the state of the art in the technology of home air conditioning. This manual serves to provide you with the instructions and explanations you need to make the best possible use of your air-conditioner. We suggest that you read it carefully before starting to use the appliance. [. . . ] If necessary, adjust the height of the conditioner using its adjustable feet. When you have finished, inspect carefully to make sure there are no fissures at the back of the air conditioner (the insulating gasket must fit firmly against the wall) particularly in the zone where air enters and leaves the machine. Once the installation of the air conditioner has been completed, place the two aesthetic shoes by sliding them on to the lower feet (see figure 10). Should a fault occur in the condensation water discharge system, the air conditioner will stop completely and all the LEDs that are alight will switch-off. To operate the unit temporarily while waiting for the arrival of the service technician, the water contained in the air conditioner can be drained by performing the following operations: - Place a container with a capacity of at least 1 litre centrally underneath the conditioner. - With the thumb and forefinger, grasp the rubber stopper located centrally in the lower part of the conditioner and remove it from its seat (fig. PERIODICAL MAINTENANCE Air conditioners of this type do not require any particular routine maintenance except: - Cleaning or washing the room air filter when the green led lights up (see user manual). - Cleaning of "external air" battery, to be done as needed, depending on the amount of dirt in the external air, once or twice a year. - Cleaning can be done using a vacuum cleaner or soft brush, taking particular care not to damage the aluminium heat exchanger baffles. It may be necessary to use water and detergents to remove heavily encrusted dirt. Before you leave the site of installation you should gather up all packing material and use a damp cloth to remove any traces of dust that may have deposited on the machine during assembly . These operations, though certainly not essential, have a beneficial effect as they enhance the professional image of the installer in the eyes of the client. To prevent unnecessary calls by the user, before you leave the site of installation it is also a good idea to: - Explain the contents of the Instruction Manual to the user. - Explain when and how he should contact the Service Department IMPORTANT RECOMMENDATIONS Installation and connection of the air conditioner should be carried out by specialized personnel in possession of the qualifications specified in Law 46/90. ) should ever obstruct the normal flow of air from either the internal or external gratings. Never lean or, worse yet, sit on the casing of the air conditioner as this could cause serious damage to the external parts. If the unit leaks water, switch it off immediately and disconnect it from the power mains. The air conditioner must not be installed in rooms where explosive gasses develop or where there are conditions of heat and humidity beyond the maximum limits indicated in the installation manual. 1) Service microkey 2) Red Stand-by LED; 3) Green LED signalling the air conditioner is switched on; 4) Orange LED signalling the switch on and/or off program is enabled; 5) Green LED signalling the appliance is running in automatic function; 6) Transparent remote control signal reception zone. REMOVING THE REMOTE CONTROL To remove the remote control from the conditioner, use the special key provided. Insert the key in the seat located on the control panel and turn it anticlockwise about 90° (fig. Grasp the rear part of the remote control and, turning it slightly, extract it from its seat. [. . . ] Act on the T7 swing button to increase or decrease the time when you want the 2nd program to stop. Every time either end of the swing button is pressed, the hour is increased or decreased by 30 minutes. To return to normal function mode, press the T6 button repeatedly until the relative indications disappear from the display. ENABLING AND DISABLING THE FUNCTION PROGRAMS (Button T9) The function programs can be enabled or disabled according to necessity. [. . . ]