User manual ALPATEC R 520 WT

[. . . ] Never use the appliance if cord plug or appliance show any sign of damage. The cord length of this product has been selected to reduce the possibility of tangling in or tripping over a longer cord. Do not place directly in front of heater or in direct sunlight as this could damage the appliance. [. . . ] Do never introduce metallic objects to avoid any risks of electrical shocks. Never use accessories that are not recommended or supplied by the manufacturer. It could constitute a danger for the user and could damage the appliance. All interventions made by a non-qualified person can be dangerous ; in this case guarantee conditions would cancel. As all electrical products, a qualified electrician must repair it, as well as the power cord must be changed by an electrician. sPECIAL RECOMMENDATIONS · Do not place any object onto the air outlet (on the back side of appliance). The rear of the unit can go quite close to the wall but leave at least 20 cm gap. The size of the ice cubes is related to the room temperature, which is why we ask you to conform to the following table: Room temperature Recommended size Your ice maker can start automatically in the next 24 hours. First, make sure that the appliance is plugged, the water tank is filled with clean water and the time is correctly adjusted. Adjust the starting time (same as local time adjustment) and use press button Start / Stop (10) to validate. Note: Do not forget to select the ice size (this can be done any time). Note: when the production will start again, the appliance will start with an ice off round in order to take out all the remaining ice in the ice making chamber (6). Note: when the production will start again, the appliance will start with an ice off round in order to take out all the remaining ice in the ice making chamber (6). Take out all the remaining cubes in the appliance (ice cube tank (5) and ice making chamber (6) if needed). [. . . ] Take out all the remaining cubes in the appliance (ice cube tank (5) and ice making chamber (6) if needed). Take out the ice tank, clean it with soft soap and rince it with clear drinking water. To completely drain the machine, smoothly tilt it (do not exceed an angle of 45°). [. . . ]