User manual ALPATEC PR3M

[. . . ] ALPATEC thanks you for buying this product and hope you will be totally satisfy with it. For your comfort and security all the steps of the manufacturing have been checked and the product succeeded in all our quality tests. [. . . ] ⷠNever use accessories that are not recommended or supplied by the manufacturer. It could constitute a danger to the user and risk to damage the appliance. ⷠAll interventions made by a non-qualified person can be dangerous; in this case guarantee conditions would cancel. This new type of heater uses MICATHERMIC heating element which is the leading heating technology. ⷠNowadays energy saving is very important for our earth, and the ECO system is tailor-made for this concept. (see details on « operating instruction part ») · This appliance can be used in bathroom (degres of protection IP 24 or Class I (volume 2)). 1- Power switch 2- ECO Green light indicator 3- Thermostat 4- Red light indicator : the appliance is connected 5- Caster (models 1500 W and 2000 W) 6- Caster frame 7- Metal grid 8- Built-in handle 9- Wall mounting hole 10- Wall mounting support 11- Screws 12- Mounting anchor for wall mounting 13- Feet cover Fix the two caster frames (6) at each side of the heater as shown in the following diagram. ⷠDrill first hole, then insert first screw anchor (12) into the first hole with a hammer. ⷠPut mounting support (10) on the wall and tighten lightly the first screw (11). ⷠMark second screw hole on the wall by raising the support in parallel to the floor. (at about 158 mm) · Drill second screw into the second hole and then insert the screw anchor (12). Fix the feet cover (13) · Place the mounting holes of the support (9) at level of screws. [. . . ] The symbol on the product, the instructions for use or the packing will inform about the methods of disposal. By recycling or others forms of re-utilization of old appliances, you are making an important contribution to protect our environment. [. . . ]