User manual ALPATEC B-C 01 I

[. . . ] ⷠAll interventions made by a non-qualified person can be dangerous; in this case guarantee conditions would cancel. ⷠWipe up any water spills immediately after loading or unloading water bottles. ⷠDo not use with water that is microbiologically unsafe or of unknown quality. Children, the disabled and the elderly are at highest risk of being scalded. [. . . ] Children, the disabled and the elderly are at highest risk of being scalded. CAUTION : Do not plug in the power cord or turn on the power switches when the waterdispenser is empty. The water dispenser should be moved by holding it on both sides with both hands, instead of lifting it at the top with one hand. 5cm) of space between the back of the water dispenser and the wall to allow proper air circulation. Do not install the water dispenser where the temperature will go below 50°F (10°C) or above 100°F (38°C). Install the water dispenser on a level floor or counter strong enough to support it when fully loaded. Do not install where it will be subject to direct sunlight, heat or moisture. The set temperature is reached when it is ON Heating power switch Cooling power switch Cooling is in progress When it is ON the set temperature is reached when it is ON --Cooling power switch the set temperature is reached when it is ON Heating power switch --F 500 FT Cool & Normal Indicates power ON F 500 CT Hot & Normal Heating is in progress when it is ON. NOTE : To use hot water function and cool water function, press 0/I button on the back side of appliance (13 and/or 14) when the button is on "I" or "marche" position, the appliance is switch on. Features/model Hot water tank capacity and first time to warm up (88°C) Icy water tank capacity and first time to cool (<12°C) Normal water Make sure the dispenser is unplugged with both the hot and cold power switched off. warning: · Do not hold the dispenser up side down to drain the water. It may cause the water flow about the inside unit and short circuit may occurs. Before turning on the power supply and connect the power switch on the water dispenser, make sure there is a bottle with sufficient water on the water dispenser, and water can flow out from both taps. Periodically the water dispenser tanks must be sanitized to prevent unpleasant tastes in the water and cleaned to remove mineral deposits that can impair flow. Before cleaning, set the power switch to off, and unplug the power cord. Completely drain the water from the bottle on the water dispenser, and remove the bottle. Do not directly inject bleaching powder into the water dispenser, as concentrated bleaching powder solution may damage plastics. Fit an adaptor onto the bottle and place it on the water dispenser (See Loading the dispenser). Press the hot water key, cold water key and cool water key (depending on respective types), so that water flows out homogeneously from both taps of the water dispenser. Drain water from the water tank of the water dispenser (see Drain from water dispenser), and put on the water dispenser plug. [. . . ] Press the hot water key, cold water key and cool water key (depending on respective types), so that water flows out homogeneously from both taps of the water dispenser. Drain water from the water tank of the water dispenser (see Drain from water dispenser), and put on the water dispenser plug. Add clean water into the water dispenser bottle and drain water from the taps until no more water flows out, and drain water from the water tank of the water dispenser (see Drain from water dispenser). Drain water from the water tank of the water dispenser (see Drain from water dispenser), put on the plug, fit the bottom cover and screws with a screwdriver. [. . . ]