User manual ALPATEC ACS 143 EITP

[. . . ] This product contains R 410A gas whose handling is regulated by the decree n° 2007-737 of May 7th 2007. Any operation in relation with refrigerant has to be done by a qualified technician. Place the appliance on a dry and level surface, with enough room, without obstacle. [. . . ] Always place the appliance in a vertical position, in order to maintain the compressor in good working conditions. Never let the appliance in a room with children and handicapped people without supervising. Do not use outdoor, in a wet environment, close to a bath-tub, a shower or a swimming pool. Do not immerse appliance or power cord · This product is provided with its own power cord. Do not use any other electrical connection but the one supplied and recommended by the manufacturer. Do not use if power cord or appliance is damaged · Only use this appliance for domestic purpose, following the instructions of that manual. In order to avoid any electrical interference, keep away from electric sources. If auto is selected, the speed will be adapted according to the difference between ambient temperature and desired temperature. If it is more than 3°C, it turns to high, if it is less than 3°C, it turns to medium and if it is 0 it turns to slow. - If you don't use the remote control for a long time, please take out batteries. - At the end of your product's life, remove the batteries before you hand it for recycling. Put the indoor unit near a window or a door and the pipe through the opening. Make the opening as small as possible to have as less hot entering as possible. Secure the outdoor unit into the two brackets by the steel spacer handles. [. . . ] Secure the outdoor unit into the two brackets by the steel spacer handles. 6meters high between the two units, moistures have to be removed using the drainage knob: - Remove the drainage knob at the back of the product - connect a Ø15/17 pipe to this hole - make sure the water flow away correctly Use a dry and wet cloth to clean the outside of the units. Remove and clean it using a vacuum cleaner or a damp cloth and dry it before replacing. [. . . ]